Abstract:Morphology development at the fiber/matrix interphase in fiber-reinforced isotactic polypropylene composites is a widely studied topic. While the application of shear flow may strongly enhance the nucleation density around the fiber, little is known about the influence of fibers on the crystallization of polypropylene subjected to an extensional flow. In this work, the flow around a single glass fiber upon uniaxial elongation of the melt is examined using X-ray scattering and diffraction techniques and compared to the response measured for the neat matrix. A comparison between a neat and compatibilized matrix is made given the strong influence of the addition of an adhesion modifier on the bulk crystallization kinetics of polypropylene. The flow is applied using an in-house-built filament stretching extensional rheometer, which, due to its midfilament control scheme, allows for in situ X-ray experiments. Combined small-angle X-ray scattering/wide-angle X-ray diffraction patterns are acquired during the flow and subsequent crystallization step. Postcrystallization area scans of the filament show that the introduction of a single glass fiber gives rise to the development of β-phase crystals, particularly in the area around the fiber ends, and in contrast to what is observed for the matrix materials alone, where solely α-phase is found. Surprisingly enough, the addition of a single fiber (0.00045 vol %) alters the crystallizing polymorph in almost the entire filament. However, the addition of the adhesion modifier hinders the formation of β-phase crystals around the fiber due to an acceleration of the bulk crystallization kinetics. Finite element simulations provide insight into the flow field around the fiber during stretching and demonstrate that the flow is no longer uniaxial extension, but dominated by shear, even though the volumetric amount of fiber as compared to the matrix is negligible. These findings explain the experimental observation of substantial β-phase formation after the introduction of a single fiber, while this is not observed in the matrix material. Worth noting, the formation of β-phase polypropylene depends not only on the presence and the strength of the flow but predominantly on the type of flow, i.e., shear as opposed to elongation.

Crystallization and crystal morphology of polymers: A multiphase-field study

Simulation of Crystallization Kinetics and Morphology During Nonisothermal Crystallization in Short Fiber Reinforced Composites

Computer Modeling of Isothermal Crystallization in Short Fiber Reinforced Composites.

A Phase Field Technique for Modeling and Predicting Flow Induced Crystallization Morphology of Semi-Crystalline Polymers

Crystallization modeling of two semi-crystalline polyamides during material extrusion additive manufacturing

Numerical Simulation of Phase Field Model for Spherulite Growth of Semi-Crystalline Polymers Using FD-FV-LB Method.

Multiscale Modeling and Simulation of Polymer Crystallization in Cooling Stage

Fiber-Induced Crystallization in Elongational Flows

Mesoscale Simulations of Spherulite Growth During Isothermal Crystallization of Polymer Melts Via an Enhanced 3D Phase-Field Model.

A thermo-mechanically coupled constitutive model for semi-crystalline polymers at finite strains: Mechanical and thermal characterization of polyamide 6 blends

Improved Polymer Crystal Phase Field Model and Numerical Simulation

Simulations on Polymer Nanocomposite Crystallization

Simulation framework for crystallization in melt flows of semi-crystalline polymers based on phenomenological models

Crystallization kinetics analysis and modeling of aerospace PAEK materials

A Phase-Field Model for Simulating Various Spherulite Morphologies of Semi-Crystalline Polymers

Tailored Morphology and Highly Enhanced Phonon Transport in Polymer Fibers: a Multiscale Computational Framework

Simulated Three Dimensional Morphological Landscape of Polymer Single Crystals by Phase-Field Model

Coarse-Grained Simulations on Polyethylene Crystal Network Formation and Microstructure Analysis

PTFE Crystal Growth in Composites: A Phase-Field Model Simulation Study

Modeling Polymer Crystallization Kinetics in the Meltblowing Process

Phase Field Modeling of the Ring-Banded Spherulites of Crystalline Polymers: the Role of Thermal Diffusion