Abstract:Morphology development at the fiber/matrix interphase in fiber-reinforced isotactic polypropylene composites is a widely studied topic. While the application of shear flow may strongly enhance the nucleation density around the fiber, little is known about the influence of fibers on the crystallization of polypropylene subjected to an extensional flow. In this work, the flow around a single glass fiber upon uniaxial elongation of the melt is examined using X-ray scattering and diffraction techniques and compared to the response measured for the neat matrix. A comparison between a neat and compatibilized matrix is made given the strong influence of the addition of an adhesion modifier on the bulk crystallization kinetics of polypropylene. The flow is applied using an in-house-built filament stretching extensional rheometer, which, due to its midfilament control scheme, allows for in situ X-ray experiments. Combined small-angle X-ray scattering/wide-angle X-ray diffraction patterns are acquired during the flow and subsequent crystallization step. Postcrystallization area scans of the filament show that the introduction of a single glass fiber gives rise to the development of β-phase crystals, particularly in the area around the fiber ends, and in contrast to what is observed for the matrix materials alone, where solely α-phase is found. Surprisingly enough, the addition of a single fiber (0.00045 vol %) alters the crystallizing polymorph in almost the entire filament. However, the addition of the adhesion modifier hinders the formation of β-phase crystals around the fiber due to an acceleration of the bulk crystallization kinetics. Finite element simulations provide insight into the flow field around the fiber during stretching and demonstrate that the flow is no longer uniaxial extension, but dominated by shear, even though the volumetric amount of fiber as compared to the matrix is negligible. These findings explain the experimental observation of substantial β-phase formation after the introduction of a single fiber, while this is not observed in the matrix material. Worth noting, the formation of β-phase polypropylene depends not only on the presence and the strength of the flow but predominantly on the type of flow, i.e., shear as opposed to elongation.

Effect of fiber orientation on spinning dynamics for liquid crystalline polymer solutions using mesoscopic theory

The evolution of crystalline structures during gel spinning of ultra-high molecular weight polyethylene fibers

Numerical Study of Melt-Spinning Dynamic Parameters and Microstructure Development with Ongoing Crystallization

In situ experimental investigation of fiber orientation kinetics during uniaxial extensional flow of polymer composites

The effect of solvent dielectric properties on the collection of oriented electrospun fibers

Numerical simulation of fiber orientation kinetics and rheology of fiber-filled polymers in uniaxial extension

Orientation Distribution and Rheological Properties of Fiber Suspensions Flowing Through Curved Expansion and Rotating Ducts

Fiber Formation and Structural Development of HBA/HNA Thermotropic Liquid Crystalline Polymer in High-Speed Melt Spinning

Orientation Distribution of Fibers and Rheological Property in Fiber Suspensions Flowing in a Turbulent Boundary Layer

THE EFFECTS OF CLOSURE MODEL OF FIBER ORIENTATION TENSOR ON THE INSTABILITY OF FIBER SUSPENSIONS IN THE TAYLOR–COUETTE FLOW

Identifying breach mechanism during air‐gap spinning of lignin–cellulose ionic‐liquid solutions

Tuning Bio-Inspired Skin-Core Structure of Nascent Fiber Via Interplay of Polymer Phase Transitions.

Fiber Orientation Distribution and Rheological Properties of Fiber Suspension in a Turbulent Jet

Shear Force Fiber Spinning: Process Parameter and Polymer Solution Property Considerations

Fiber-Induced Crystallization in Elongational Flows

Investigation into shear-thinning behavior in wet spinning of carbon nanotube fibers modeled by power law viscosity model

Experimental Validation of a Direct Fiber Model for Orientation Prediction

Complex dynamics of long, flexible fibers in shear

Continuum Mechanical Modeling of Liquid Crystal Elastomers As Dissipative Ordered Solids

Dynamics of Entangled Polymeric Fluids in Two-roll Mill studied via Dynamic Light Scattering and Two-color flow Birefringence. I. Steady flow

Shear-enhanced Liquid Crystal Spinning of Conjugated Polymer Fibers