Abstract:For the better design of large scale CFB boilers, reliable multi-dimensional modeling which can be used to predict the heterogeneous distributions of gas and solid concentration as well as temperature in the furnace is necessary and demanded.A model describing the complex combustion process in a CFB boiler furnace has been developed. The model consists of several essential sub-parts: the hydrodynamics of the bed, combustion of fuel, and overall mass balance of the furnace. In the computational fluid dynamics (CFD) study on hydrodynamics in a CFB boiler, the Euler-Euler approach is used, in which both gas and solid phases are considered as interpenetrating continua with the interaction through drag and energy dissipation caused by particle fluctuation. The constitutive equations for solid phase are derived from the kinetic theory of granular flow (KTGF). Some simplifications of the complicated theoretical equations with empirical correlations are adopted, to save computing time and skip the currently unknown phenomena. Drag coefficient between gas phase and solid phase is modified by the energy-minimization multi-scale (EMMS) principle. A simplified description of reaction process is also adopted.The present model was applied to predict the hydrodynamic and combustion behaviors in a commercial 135 MWe CFB boiler. Some primary results are obtained and discussed in comparison with the measured data. Prediction results agree with the experimental data in general, confirming the correctness of the model. More reliable experiments are needed for the model improvement in the future.

CFD Modeling of Phase Change and Coke Formation in Petroleum Refining Heaters

Modeling, Simulation and Optimization of Commercial Naphtha Catalytic Reforming Process

Advanced Modeling Approaches for CFD Simulations of Coal Combustion and Gasification

Fluid Dynamic Numerical Simulation Coupled With Heat Transfer And Reaction In The Tubular Reactor Of Industrial Cracking Furnaces

CFD simulation of combustion and heat transfer in ethylene cracking furnace

Numerical simulation on flow, combustion and heat transfer of ethylene cracking furnaces

Comprehensive Cfd Simulation of Product Yields and Coking Rates for A Floor- and Wall-Fired Naphtha Cracking Furnace

CFD Modelling of the Co-Gasification of Biomass and Coal Particles in Fluidised Beds

CFD-DEM Study on the Synergistic Effect of Coke Consumption and Particle Dynamics in the Blast Furnace Raceway

Numerical Simulation of the Flue Gas Side of Refining Vacuum Furnace Using CFD

CFD Modeling of Coal Pyrolysis in Externally Heated Fixed-Bed Reactor

Modeling approach and numerical analysis of a roller-hearth reheating furnace with radiant tubes and heating process optimization

CFD investigation on the flow and combustion in a 300 MWe tangentially fired pulverized-coal furnace

Prediction of molecular distribution and temperature profile of FCC process through molecular-level kinetic modeling

Combustion Modeling Of Cfb Boiler Furnace Based On An Euler-Euler Approach

CFD Simulation of Propane Cracking Tube Using Detailed Radical Kinetic Mechanism

Three-Dimensional Modeling of an Ironmaking Blast Furnace with a Layered Cohesive Zone

Transient Behavior of an Industrial-Scale Coke Oven: CFD Modeling and Simulation with a Fully Coupled Heating and Coking Model

Coupled Simulation of Recirculation Zonal Firebox Model and Detailed Kinetic Reactor Model in an Industrial Ethylene Cracking Furnace

3D numerical simulation of Texaco gasifier using assumed PDF model

Kinetic Model and CFD Simulation for an Entrained Flow Coal Hydrogasifier and Influence of Structural Parameters