Abstract:To explore the gasification characteristics of brewer's spent grains (BSGs) in a fluidized bed gasifier with air and water vapor as gasification agents, a numerical simulation model with computational particle fluid dynamics (CPFD) of 3D bubbling fluidized-bed gasifier was established, and gasification properties was investigated based on CPFD simulation. The thermogravimetric mass spectrometry (TG-MS) was used to investigate the main components in the volatiles released during the pyrolysis of BSGs, for providing benchmark data of gasification raw materials. The effects of temperature T, equivalence ratio ER, steam-to-BSGs mass ratio S/B and fluidization velocity u(g) on the gasification properties, were investigated using CPFD analysis. The results showed that when the gasification temperature increased from 700 degrees C to 900 degrees C, the mole fractions of CO and H-2 in the product gas increased from 9.80 % and 3.95 % to 16.00 % and 14.21 % respectively, and the low heating value of the product gas increased from 3.36 MJ center dot Nm(-3) to 4.35 MJ center dot Nm(-3). As ER value increased from 0.2 to 0.4, the carbon conversion fraction increased from 78.8 % to 85 %, but the molar fractions of H-2 and low heating value of the product gas both decreased. When S/B value increased from 0.3 to 0.7, the molar fraction of H-2 increased from 6.54 % to 11.76 %, while the molar fraction of CO and CH4 decreased from 13.59 % and 3.97 % to 11.37 % and 3.84 % respectively. With u(g) value increasing from 0.15 m center dot s(-1) to 0.75 m center dot s(-1), the molar fraction of H-2 and CO increased from 8.11 % and 9.61 % to 11.63 % and 17.01 % respectively, owing to strengthened particle mixing. However, with further increase of u(g), the molar concentrations of H-2 and CO above the splash zone both decreased, due to a portion of BSGs particles being brought out by fluidizing gas from the top outlet of the gasifier. The numerical simulation results were validated by the experiments in a bubbling fluidized-bed gasifier. They underestimated CO2 production, slightly overestimated the mole fraction of H-2 with a maximum error of 9.54 %, overestimated the mole fraction of CO in the vast majority of cases, and estimated the mole fraction of CH4 with a maximum error of only 6.67 %.

Variable pressure pulsation frequency optimization in gas double-dynamic solid-state fermentation (GDSSF) based on heat balance model

Numerical simulation of pressure fluctuation in gas-solids agitated fluidized bed

Evaporator Performance Enhancement by Pulsation Width Modulation (PWM)

Gray Wolf Optimizer with Bubble-Net Predation for Modeling Fluidized Catalytic Cracking Unit Main Fractionator

Optimization of Dual-Impeller Configurations in a Gas–Liquid Stirred Tank Based on Computational Fluid Dynamics and Multiobjective Evolutionary Algorithm

Realization and Control of Multiple Temperature Zones in Liquid‐containing Gas–solid Fluidized Bed Reactor

Control of Pressure Balance and Solids Circulation Characteristics in DCFB Reactors

Effect of the Technique of Variable Frequency Governing on Safety Operation of Boiler Feed-water Pump

Multi-Scale Simulation of Biomass Gasification in Fluidized Beds

Process Calorimetry on Solid-State Fermentation of Vinegar Wastes in Bioreactor with Air Pressure Pulsation

Investigation of Unstable Solids Circulation Behavior in A Circulating Fluidized Bed with Sweeping Bend Return Using Pressure Frequency Analysis

N2 periodic pulsation process intensification to improve ethanol productivity in solid state fermentation of steam-exploded corn stalk

Optimal Temperature and pH Control for a Batch Simultaneous Saccharification and Co-Fermentation Process

Pulsation effects on mixing behaviour of binary particles with different densities in supercritical water fluidized bed reactors: A CFD-DEM study

Numerical simulation of GSP gasifier based on double-mixture fractions PDF model

A Solid-State Bioreactor Coupled with Forced Aeration and Pressure Oscillation

CPFD Modeling of Air-Steam Gasification of Brewer’s Spent Grains in a Bubbling Fluidized Bed

Numerical Simulation of Transient Radial Temperature Distribution in Rotating Drum Bioreactor for Solid State Fermentation

Enhancing Microalgal Biomass Productivity with an Optimized Flow Field Generated by Double Paddlewheels in a Flat Plate Photoreactor with CO2 Aeration Based on Numerical Simulation

CPFD modeling of air-steam gasification of brewer's spent grains in a bubbling fluidized bed

Simulation Test of Self-stirring in Dry Anaerobic Fermentation Based on Releasing Pressurized Biogas