Abstract:A remarkably rich variety of nanophase-separated structures and various order-order transitions are observed in a series of low-molecular weight (MW) rod-coil block copolymers (BCPs) with the rod blocks of different lengths (L-Rod's). The rod-coil diblock copolymer studied herein is poly(dimethylsiloxane)-b-poly{2,5-bis[(4-methoxyphenyl)oxycarbonyl]styrene} (PDMS-b-PMPCS), in which PMPCS is a rod-like polymer and exhibits an MW-dependent liquid crystalline (LC) phase behavior. When the polymerization degree of the PMPCS rod block (N-Rod) is less than 32 (L-Rod < 8 nm), the PMPCS block is always amorphous in the entire temperature range. And the corresponding PDMS-b-PMPCS BCPs with N-Rod from 11 to 29 and the volume fraction of the PMPCS rod (f(Rod)) from 43% to 67% self-assemble into various equilibrium nanostructures after annealed at temperatures above the glass transition temperatures of the PMPCS blocks. When N-Rod = 11 and f(Rod) = 43%, the BCP forms a lamellar structure (LAM); when N-Rod = 15 and f(Rod) = 51%, the BCP forms a double gyriod structure (GYR) ; when N-Rod = 20 and f(Rod) = 57%, the BCP forms a GYR structure after annealed below 180 degrees C and transforms to the Fddd structure after annealed above 180 degrees C; when N-Rod = 29 and f(Rod) = 67%, the nanostructure of the BCP after annealed below 180 degrees C is hexagonally packed cylinders (HEX) and changes to a body centered cubic structure (BCC) after annealed above 180 degrees C. When N-Rod > 32 (L-Rod > 8 nm), the PMPCS rod block is amorphous at low temperatures and transforms to a stable columnar LC phase after annealed at high temperatures. Correspondingly, the PDMS-b-PMPCS BCP with N-Rod = 44 and f(Rod) = 75% forms a HEX structure after annealed at lower temperatures at which the PMPCS block is amorphous, and the nanostructure transforms to LAM after the sample is annealed at higher temperatures at which the PMPCS block enters into the LC phase. Therefore, only by a small change of the rod length in the low-MW PDMS-b-PMPCS rod-coil BCPs, various nanostructures including LAM, GYR, Fddd, HEX, and BCC are obtained. In addition, by increasing annealing temperatures, GYR-to-Fddd and HEX-to-BCC transitions are observed in the BCPs with the amorphous PMPCS, and a HEX-to-LAM transition occurs in the BCP when the LC PMPCS block undergoes an isotropic-to-LC phase transformation.

Hierarchically Ordered Aba Triblock Copolymer With Large Difference In Glass Transition Temperatures Of The Two Blocks

Preparation of Triblock Copolymers with High &ITCis&IT-1,4-polybutadiene as Soft Segments

Preparation of Triblock Copolymers with High Cis-1,4-polybutadiene as Soft Segments

Observation of Double Gyroid and Hexagonally Perforated Lamellar Phases in ABCBA Pentablock Terpolymers

Effect of Poly(4‑tert-Butylstyrene) Block Length on the Microphase Structure of Poly(ethylene Oxide)-B-poly(4-vinylbenzyl Chloride)-B-poly(4‑tert-butylstyrene) Triblock Terpolymers

PAA-b-PPO-b-PAA Triblock Copolymers with Enhanced Phase Separation and Inverse Order-to-order Phase Transition Upon Increasing Temperature

An ABA triblock containing a central soft block of poly[2,5-di(n-hexogycarbonyl)styrene] and outer hard block of poly(4-vinylpyridine): synthesis, phase behavior and mechanical enhancement

ABA Type Liquid Crystalline Triblock Copolymers by Combination of Living Cationic Polymerizaition and ATRP: Synthesis and Self-Assembly.

Synthesis and Self-Assembly of A Linear Coil-Coil-Rod Abc Triblock Copolymer

Thermoreversible Order−Order Transition of a Triblock Copolymer Containing a Mesogen‐Jacketed Liquid Crystalline Polymer with a Re‐Entrant Phase Behavior

Thermoreversible Order–Order Transition of a Diblock Copolymer Induced by the Unusual Coil–Rod Conformational Change of One Block

Remarkably Rich Variety of Nanostructures and Order–Order Transitions in a Rod–Coil Diblock Copolymer

Synthesis and Self-Assembly of Rod–Rod Block Copolymers with Different Rod Diameters

Low Tg, strongly segregated, ABA triblock copolymers: a rheological and structural study

Aba Type Triblock Copolymer Based on Mesogen-Jacketed Liquid Crystalline Polymer: Design, Synthesis, and Potential As Thermoplastic Elastomer

Synthesis and Characterization of Poly(dimethylamino Ethyl Methacrylate)–poly(ethylene Oxide)–poly(dimethylamino Ethyl Methacrylate) Triblock Copolymers

Order-order transition induced by mesophase formation in a novel type of diblock copolymers based on poly(isobutyl methacrylate) and poly[2,5-di(isopropyloxycarbonyl)styrene]

Synthesis of an Optically Active Triblock Copolymer and Its Self-Assembly Behavior in Dioxane/Water

Synthesis and Self-Assembly Behavior of Polyhedral Oligomeric Silsesquioxane-Based Triblock Copolymers in Selective Solvents by Dissipative Particle Dynamics Simulation

Synthesis of Well-Defined Amphiphilic Polymethylene-B-Poly(E-Caprolactone)-B-Poly(Acrylic Acid) Triblock Copolymer Via A Combination of Polyhomologation, Ring-Opening Polymerization, and Atom Transfer Radical Polymerization

Synthesis, order-to-disorder transition, microphase morphology and mechanical properties of BAB triblock copolymer elastomers with hard middle block and soft outer blocks