Abstract:The living cationic sequential block copolymerization of isobutylene (IB) with tert-butyl vinyl ether (tBVE) was studied using a one-pot procedure in hexanes/CH2Cl2 and hexanes/CH3Cl solvent systems at -80 degreesC. It was carried out by the so-called capping-tuning technique, involving the capping of living PIB chain ends with 1,1-ditolylethylene (DTE) followed by addition of titanium(IV) isopropoxide (Ti(OIp)(4)) to lower the Lewis acidity before the introduction of tBVE. Homopolymerizations/model block copolymerizations of tBVE were carried out using 2-chloro-2,4,4-trimethylpentane (TMPCl) instead of living PIB. The living nature was exhibited by the linear plots of ln([M](0)/[M]) vs time and number average molecular weight (M-n) vs conversion. C-13 NMR spectroscopy indicated that the PtBVE is highly isotactic with close to 80% meso dyads. Well-defined PIB-b-PtBVE diblock copolymers were synthesized by the living cationic polymerization of IB followed by capping the living PIB ends with DTE and fine-tuning the Lewis acidity to obtain 100% crossover efficiency and a desired tBVE polymerization rate. While both hexanes/CH2Cl2 and hexanes/CH3Cl solvent systems could be used, the polymerization was better controlled and the product exhibited narrower molecular weight distribution (MWD) in hexanes/CH3Cl solvent mixtures. Well-defined triblock copolymers with close to designed molecular weights and narrow MWDs (<1.1) were prepared using 5-tert-butyl-1,3-bis(1-chloro-1-methylethyl)benzene (tBuDiCumCl) as a difunctional initiator. Differential scanning calorimetry (DSC) of the block copolymers showed two glass transitions demonstrating microphase separation. The triblock copolymers with 23-39 wt % PtBVE content exhibited typical characteristics of a thermoplastic elastomer (TPE) with tensile strengths of 9-15 MPa and elongations at break of 760-1300%. Morphological studies by transmission electron microscopy (TEM), small-angle X-ray-scattering (SAXS), and atomic force microscopy (AFM) revealed lamellar or cylindrical morphologies of the triblock copolymers, depending on their molecular compositions.

Preparation of Triblock Copolymers with High Cis-1,4-polybutadiene as Soft Segments

Preparation of Triblock Copolymers with High &ITCis&IT-1,4-polybutadiene as Soft Segments

Facile Access To Carboxyl-Terminated Polybutadiene And Polyethylene From Cis-Polybutadiene Rubber

Synthesis and Characterization of Symmetrical Triblock Copolymers Containing Crystallizable High- Trans -1,4-Polybutadiene

Synthesis and Characterization of Linear-shaped and 3-Arm Star-shaped Hydroxyl-terminated Polybutadiene via Living Anionic Polymerization

Synthesis and Characterization of Novel Poly(ε-CL)-block-HTPB-block-poly(ε-CL) Triblock Copolymer

Synthesis and Characterization of Stereotriblock Polybutadiene Containing Crystallizable High Trans-1,4-Polybutadiene Block by Barium Salt of Di(Ethylene Glycol) Ethylether/Triisobutylaluminium/Dilithium

Synthesis of Block Copolymers Containing Polybutadiene Segments by Combination of Coordinative Chain Transfer Polymerization, Ring‐Opening Polymerization, and Atom Transfer Radical Polymerization

Preparation of a P(THF-co-PO)-b-PB-b-P(THF-co-PO) triblock copolymer via cationic ring-opening polymerization and its use as a thermoset polymer

Synthesis, Characterization, And Morphology Of Poly(Tert-Butyl Vinyl Ether-B-Isobutylene-B-Tert-Butyl Vinyl Ether) Triblock Copolymers

Synthesis and characterization of PSt-b-PDMS-b-PSt triblock copolymers

Synthesis and Comparative Study of Polyether- b-polybutadiene- b-polyether Triblock Copolymers for Use as Polyurethanes

Supramolecular thermoplastic elastomers via self‐complementary quadruple hydrogen bonding between polybutadiene‐based triblock copolymers

An ABA triblock containing a central soft block of poly[2,5-di(n-hexogycarbonyl)styrene] and outer hard block of poly(4-vinylpyridine): synthesis, phase behavior and mechanical enhancement

Synthesis and thermal decomposition kinetics of tri-block copolymer ε-caprolactone / polybutadiene (PCL-PB-PCL); preparation of polyurethane network-based tri-block copolymer

Synthesis and Characterization of Liquid Crystalline Copolymers Containing Poly (ether Sulfone) Segments

Synthesis of Poly(butylene Terephthalate)-Block-poly(ethylene Oxide)-Block-poly(propylene Oxide)-Block-poly(ethylene Oxide) Multiblock Terpolymers Via a Facile PROP Method

Synthesis and Characterization of Poly(Butylene Terephthalate)-Co-Poly(Butylene Succinate)-B-Poly (ethylene Glycol) Segmented Block Copolymers

Synthesis of Well-Defined Amphiphilic Polymethylene-B-Poly(E-Caprolactone)-B-Poly(Acrylic Acid) Triblock Copolymer Via A Combination of Polyhomologation, Ring-Opening Polymerization, and Atom Transfer Radical Polymerization

Synthesis And Characterization Of Poly(Epsilon-Caprolactone)-B-Poly(Ethylene Glycol)-B-Poly(Epsilon-Caprolactone) Triblock Copolymers With Dibutylmagnesium As Catalyst

Synthesis and Characterization of Isotactic Poly( P-Hydroxystyrene)- Block-1,4- Trans- Polybutadiene by Sequential Monomer Addition Using Titanium Com Plex with an [Osso]-Ty Pe Bis( Phenolate) Ligand