Abstract:Rigid-plastic finite element method considering, thermo-mechanical coupling was used to investigate the thermal forging process of a cubical-shaped 7075 aluminum alloy piece, and the Yada model was adopted to calculate the grain refinement in the process. The simulation results show that the distribution of stress, strain, strain rate and temperature of the forging piece are not uniform, and according to the distribution of these physical quantities, the forging piece can be divided into four characteristic zones: the center ellipsoidal zone, the contact edge zone, the vertical edge zone and conical contact zone, where the first two zones are easy to deform, and the remained two zones are difficult to deform. The grain refinement begins from the center ellipsoidal zone, and then gradually expands to the vertical edge zone and conical contact zone. The comparison analysis of different forging parameters shows that temperature and compression strain rate is the major forging parameters controlling grain size. The grains of 7075 aluminum alloy can be further refined. with the increase of compression strain rate, but high compression strain rate will bring the excessive heat that will make grains to grow. Then a set of suggested forging parameters are given as follows, the initial temperature should be 350 degrees C similar to 400 degrees C, the compression strain rate should be 70 s(-1)similar to 100 s(-1), and the compression ratio should be 20%similar to 25%. And finally, the limitation and application region of Yada model are also discussed.

INTEGRATED SIMULATION OF THE FORGING PROCESS FOR GH4738 ALLOY TURBINE DISK AND ITS APPLICATION

Numerical Simulation of GH4169 Alloy Disc Forging Process on Counterblow Hammer

Numerical simulation of grain refinement of 7075 aluminum alloy in forge processing

FE simulation of grain size and temperature rise during the forging of a commercial TC6 titanium alloy disc

3D Numerical Simulation of Axial Closed Dies Rolling Process for Disk Forging

Numerical Simulation of Process and Grain Size for Large-Sized Aluminum Alloy 7050 Forging

Finite Element Simulation of Grain Size During Isothermal Forging Process of the TC4 Aerofoil Blade

Residual Stress Analysis of the Multi-Stage Forging Process of a Nickel-Based Superalloy Turbine Disc

Working Characteristics and Numerical Simulation of Forging Process for Clutch Screw Press

A Novel Unified Model Predicting Flow Stress and Grain Size Evolutions During Hot Working of Non-Uniform As-Cast 42crmo Billets

Modeling and Simulation of Austenite Grain Evolution for Heavy Forging Steel 30cr2ni4mov Undergoing Hot Deformation

Numerical simulation of grain size during isothermal forging of TC6 alloy

Experimental Investigation and Numerical Simulation of the Grain Size Evolution During Isothermal Forging of A Tc6 Alloy

Finite element simulation of isothermal forging of complex component using constitutive relationship of 7A04 alloy

Finite element simulation and experiment of isothermal die forging process of TC18 Ti alloy disc

Finite Element Simulation Of Superplastic Isothermal Forging Process For Nickel-Base Pm Superalloy

FEM simulation of forging of Ti alloy

Numerical Simulation and Experimental Study on Forging Process of Ultra-Super-critical HP-IP Rotor Steel

Numerical Simulation Research on Final Forging Process of 700MW Class Heavy Hydro-generator Shaft

Effect of Multiple Forging on Microstructure and Mechanical Properties of Powder Metallurgy Fgh4096 Superalloy

Optimization of multi-directional forging parameters of large-scale Mg-Gd-Y-Zn-Zr alloy forged part guided by finite element simulation