Abstract:Purpose: X-ray fluorescence computed tomography (XFCT) is an emerging molecular imaging modality for preclinical and clinical applications with high atomic number contrast agents. XFCT allows detection of molecular biomarkers at tissue depths of 4-9 mm at L-shell energies and several centimeters for K-shell energies, while maintaining high spatial resolution. This is typically not possible for other molecular imaging modalities. The purpose of this study is to demonstrate XFCT imaging with reduced acquisition times. To accomplish this, x-ray focusing polycapillary optics are utilized to simultaneously increase x-ray fluence rate and spatial resolution in L-shell XFCT imaging. Materials and methods: A prototype imaging system using a polycapillary focusing optic was demonstrated. The optic, which was custom-designed for this prototype, provided a high fluence rate with a focal spot size of 2.6 mm at a source to isocenter distance of 3 cm with a ten times higher fluence rate compared to standard collimation. The study evaluates three different phantoms to explore different trade-offs and limitations of L-shell XFCT imaging. A low-contrast gold phantom and a high-contrast gold phantom, each with three target regions with gold concentrations of 60, 80, and 100 μg ml - 1 for low contrast and 200, 600, and 1000 μg ml - 1 for high contrast, and a mouse-sized water phantom with gold concentrations between 300 and 500 μg ml - 1 were imaged. X-ray fluorescence photons were measured using a silicon drift detector (SDD) with an energy resolution of 180 eV FWHM at an x-ray energy of 11 keV. Images were reconstructed with an iterative image reconstruction algorithm and analyzed for contrast to noise ratio (CNR) and signal to noise ratio (SNR). Results: The XFCT data acquisition could be reduced from 17 h to under 1 h. The polycapillary x-ray optic increases the x-ray fluence rate and lowers the amount of background scatter which leads to reduced imaging time and improved sensitivity. The quantitative analysis of the reconstructed images validates that concentrations of 60 μg ml - 1 of gold can be visualized with L-shell XFCT imaging. For a mouse-sized phantom, a concentration of 300 μg ml - 1 gold was detected within a 66 min measurement. Conclusions: With a high fluence rate pencil beam from a polycapillary x-ray source, a reduction in signal integration time is achieved. It is presented that subtle amounts of contrast agents can be detected with L-shell XFCT within biologically relevant time frames. Our basic measurements show that the polycapillary x-ray source technology is appropriate to realize preclinical L-shell XFCT imaging. The integration of more SDDs into the system will lower the dose and increase the sensitivity.

Application of Polycapillary X Ray Lens to Eliminate Both the Effect of X Ray Source Size and Scatter of the Sample in Laboratory Tomography

Grating-Based X-Ray Phase Contrast Imaging With a Polycapillary Semilens

Full-Field Transmission X-Ray Imaging With Confocal Polycapillary X-Ray Optics

Optimization of Image Quality and Acquisition Time for Lab-Based X-ray Microtomography Using an Iterative Reconstruction Algorithm

Poly-Capillary X-Ray Collimating Lens Composed With Channels Of Different Diameters For Medical Imaging

Scattering-compensated Cone Beam X-Ray Luminescence Computed Tomography

Quasi-parallel X-ray microbeam obtained using a combined system of polycapillary optics

X-ray Fluorescence Microtomography Based on Polycapillary-Focused X-rays from Laboratory Source

Performance of Polycapillary X‐ray Lens for X‐ray Sources with Various Spot Sizes

X-ray Lens of Monolithic Polycapillaries for Macromolecular Crystallography.

Monochromatic X-ray Imaging Using a Combination of Doubly Curved Crystal and Polycapillary X-ray Lens.

Magnified X Ray Ghost Imaging with Tapered Polycapillary Optics Free of the Penumbra Effect

Application Of A Combined System Of Polycapillary X-Ray Lens And Toroidal Mirror In Micro-X-Ray-Absorption Fine-Structure Facility

High-energy High-Dose Microfocus X-ray Computed Tomography Driven by High-Average-current Photo-Injector.

Laboratory x-ray nano-computed tomography for biomedical research

Reduced acquisition time for L-shell x-ray fluorescence computed tomography using polycapillary x-ray optics

Quasi-parallel X-ray microbeam obtained using a parabolic monocapillary X-ray lens with an embedded square-shaped lead occluder

Characterization of polycapillary X-ray lens for application in confocal three-dimensional energy-dispersive micro X-ray diffraction experiments

Study on the X-ray Transmission Characteristics of Monolithic Poly-Capillary Quasi-Parallel Lens Composed with Different Diameter Tubes