Abstract:Structural Health Monitoring, Ahead of Print. The stiffness and strength properties of freshly poured concrete develop over time as the concrete hardens due to curing. The monitoring of such properties therefore enables timely construction decisions such as formwork removal. Traditional point-in-time destructive tests can be cumbersome, while continuous non-destructive testing is desirable. Piezoelectric-based electromechanical impedance (EMI) and wave propagation (WP) techniques fall into the latter, and they have been verified for monitoring concrete properties during curing in the laboratory. This paper reports the first field application of the EMI and WP techniques for monitoring concrete curing, where smart aggregate (SA) sensors are embedded into concrete pour strips of a multi-storey residential building during construction. For comparison and verification purposes, destructive compression and non-destructive ultrasonic pulse velocity (UPV) tests were conducted. Results obtained from both EMI and WP techniques were consistent and repeatable. They were also comparable to the UPV result, and they showed a close correlation to the compressive strength tests. The current study has also revealed that the electrical signatures acquired from the EMI and WP techniques have a linear relationship. EMI-based and WP-based semi-analytical models (and their derivations) that can quantify the compressive strength and modulus of elasticity of concrete at various curing durations are also presented. This reported study ultimately demonstrates the applicability and practical application of the EMI and WP techniques for real-time measurements, bridging the gap between laboratory-based studies and field applications.

Feasibility of Water Seepage Monitoring in Concrete with Embedded Smart Aggregates by P-Wave Travel Time Measurement

Two-dimensional Water Seepage Monitoring in Concrete Structures Using Smart Aggregates

Exploratory Study on Water Seepage Monitoring of Concrete Structures Using Piezoceramic Based Smart Aggregates

Monitoring depth and width of cracks in underwater concrete structures using embedded smart aggregates

Exploratory Study on Sulfate Attack Monitoring of Concrete Structures Using Piezoceramic Based Smart Aggregates

Monitoring of Concrete Structure Damage Caused by Sulfate Attack with the Use of Embedded Piezoelectric Transducers

Attenuation characteristics of concrete using smart aggregate transducers: Experiments and numerical simulations of P-wave propagation

An Experimental Study on the Performance of Piezoceramic-Based Smart Aggregate in Water Environment

Feasibility of SA–based Concrete Seismic Stress Monitoring for High-Strength Concrete

Real-Time Monitoring of Water Content in Sandy Soil Using Shear Mode Piezoceramic Transducers and Active Sensing—A Feasibility Study

Monitoring of soil water content using spherical smart aggregates based on electromechanical impedance (EMI) technique

Smart Aggregates for Monitoring Stress in Structural Lightweight Concrete

Water Transport in Unsaturated Cracked Concrete under Pressure

Ultrasonic monitoring of the early-age hydration of mineral admixtures incorporated concrete using cement-based piezoelectric composite sensors

Seismic shear stress measurement using PZT based smart aggregate

A New Test Method to Simulate Chloride Penetration into Concrete in Tidal Zone

Smart Aggregates Used For Seismic Stress Monitoring In Concrete Structures

Monitoring the curing process of in-situ concrete with piezoelectric-based techniques – A practical application

A solitary wave-based sensor to monitor the setting of fresh concrete

Damage Detection of L-Shaped Concrete Filled Steel Tube (L-CFST) Columns under Cyclic Loading Using Embedded Piezoceramic Transducers

Application Research on Surface Wave Technique in Crack Depth Detection of Hydraulic Concrete