Abstract:A visible-infrared multispectral synchronous imaging pyrometer was developed for simultaneous, multispectral, two-dimensional high temperature measurements. The multispectral image pyrometer uses prism separation construction in the spectrum range of 650–950 nm and multi-sensor fusion of three CCD sensors for high-temperature measurements. The pyrometer had 650–750 nm, 750–850 nm, and 850–950 nm channels all with the same optical path. The wavelength choice for each channel is flexible with three center wavelengths (700 nm, 810 nm, and 920 nm) with a full width at half maximum of the spectrum of 3 nm used here. The three image sensors were precisely aligned to avoid spectrum artifacts by micro-mechanical adjustments of the sensors relative to each other to position them within a quarter pixel of each other. The pyrometer was calibrated with the standard blackbody source, and the temperature measurement uncertainty was within 0.21 °C–0.99 °C in the temperatures of 600 °C–1800 °C for the blackbody measurements. The pyrometer was then used to measure the leading edge temperatures of a ceramics model exposed to high-enthalpy plasma aerodynamic heating environment to verify the system applicability. The measured temperature ranges are 701–991 °C, 701–1134 °C, and 701–834 °C at the heating transient, steady state, and cooling transient times. A significant temperature gradient (170 °C/mm) was observed away from the leading edge facing the plasma jet during the steady state heating time. The temperature non-uniformity on the surface occurs during the entire aerodynamic heating process. However, the temperature distribution becomes more uniform after the heater is shut down and the experimental model is naturally cooled. This result shows that the multispectral simultaneous image measurement mode provides a wider temperature range for one imaging measurement of high spatial temperature gradients in transient applications.

Temperature Measurements of High-Temperature Semi-Transparent Infrared Material Using Multi-Wavelength Pyrometry

Radiation temperature measurement method for semitransparent materials using one-channel infrared pyrometer.

Measurement Method for High-Temperature Infrared Optical Constants of ZnS Crystal Materials in a Multi-Layer Structure

Temperature measurements using multicolor pyrometry in thermal radiation heating environments.

Optical Temperature Sensor Based On Zno Thin Film'S Temperature-Dependent Optical Properties

Measurements of spectral emissivity, reflectance and transmittance at high temperatures using laser heating and auxiliary light source

VIS-NIR Multispectral Synchronous Imaging Pyrometer for High-Temperature Measurements.

Spectral Stray Light Effect on High-Temperature Measurements Using A Near-Infrared Multi-Wavelength Pyrometer

Quantitative Infrared Spectroscopy of Environmentally Sensitive and Rough Materials.

Non-contact temperature field measurement of solids by infrared multispectral thermotransmittance

Multispectral radiation temperature data processing algorithm for high temperature complex material surface

Infrared thermotransmittance-based temperature field measurements in semitransparent media

Visible and Near-Infrared, Multiparametric, Ultrasensitive Nanothermometer Based on Dual-Emission Colloidal Quantum Dots

Parameters inversion of ZnS multi-phonon absorption model based on the transmissivities in variable temperature

Simultaneous measurement of normal spectral emissivity and temperature of materials with low thermal conductivity

Spectral Pyrometry for Practical Temperature Measurement in the TEM

Multidimensional high-temperature field measurement method for flame based on near infrared radiation spectrum of water vapor

Measurement of High-temperature Thermophysical Properties of Bulk and Coatings Using Modulated Photothermal Radiometry

A novel multi-band plenoptic pyrometer for high-temperature applications

Infrared thermometry in high temperature materials processing: influence of liquid water and steam

Measurement of High-Temperature Spectral Emissivity Using Integral Blackbody Approach