Abstract:A visible-infrared multispectral synchronous imaging pyrometer was developed for simultaneous, multispectral, two-dimensional high temperature measurements. The multispectral image pyrometer uses prism separation construction in the spectrum range of 650–950 nm and multi-sensor fusion of three CCD sensors for high-temperature measurements. The pyrometer had 650–750 nm, 750–850 nm, and 850–950 nm channels all with the same optical path. The wavelength choice for each channel is flexible with three center wavelengths (700 nm, 810 nm, and 920 nm) with a full width at half maximum of the spectrum of 3 nm used here. The three image sensors were precisely aligned to avoid spectrum artifacts by micro-mechanical adjustments of the sensors relative to each other to position them within a quarter pixel of each other. The pyrometer was calibrated with the standard blackbody source, and the temperature measurement uncertainty was within 0.21 °C–0.99 °C in the temperatures of 600 °C–1800 °C for the blackbody measurements. The pyrometer was then used to measure the leading edge temperatures of a ceramics model exposed to high-enthalpy plasma aerodynamic heating environment to verify the system applicability. The measured temperature ranges are 701–991 °C, 701–1134 °C, and 701–834 °C at the heating transient, steady state, and cooling transient times. A significant temperature gradient (170 °C/mm) was observed away from the leading edge facing the plasma jet during the steady state heating time. The temperature non-uniformity on the surface occurs during the entire aerodynamic heating process. However, the temperature distribution becomes more uniform after the heater is shut down and the experimental model is naturally cooled. This result shows that the multispectral simultaneous image measurement mode provides a wider temperature range for one imaging measurement of high spatial temperature gradients in transient applications.

Radiation temperature measurement method for semitransparent materials using one-channel infrared pyrometer.

Temperature Measurements of High-Temperature Semi-Transparent Infrared Material Using Multi-Wavelength Pyrometry

Measurement Method for High-Temperature Infrared Optical Constants of ZnS Crystal Materials in a Multi-Layer Structure

Measurement of radiation temperature with high time-resolution

Optical Temperature Sensor Based On Zno Thin Film'S Temperature-Dependent Optical Properties

Spectral Emissivity and Transmissivity Measurement for Zinc Sulphide Infrared Window Based on Integrating-Sphere Reflectometry

Temperature measurements using multicolor pyrometry in thermal radiation heating environments.

Measurements of spectral emissivity, reflectance and transmittance at high temperatures using laser heating and auxiliary light source

Quantitative Infrared Spectroscopy of Environmentally Sensitive and Rough Materials.

Spectral Stray Light Effect on High-Temperature Measurements Using A Near-Infrared Multi-Wavelength Pyrometer

VIS-NIR Multispectral Synchronous Imaging Pyrometer for High-Temperature Measurements.

Multi-phonon interaction of ZnS material based on two-dimensional correlation analysis

A high-speed, eight-wavelength visible light-infrared pyrometer for shock physics experiments

A Method for Measuring Thermal Radiation Properties of Semi-Transparent Materials

Analysis of radiation effect on thermal conductivity measurement of semi-transparent materials based on transient plane source method

InAsSb Photodiode Fibre Optic Thermometry for High-Speed, near-Ambient Temperature Measurements

Parameters inversion of ZnS multi-phonon absorption model based on the transmissivities in variable temperature

Spectral Pyrometry for Practical Temperature Measurement in the TEM

Non-contact temperature field measurement of solids by infrared multispectral thermotransmittance

Infrared thermotransmittance-based temperature field measurements in semitransparent media

Improvements to the Three-Color Optical CCD-based Pyrometer System