Abstract:Porous titanium (Ti) has attracted much attention due to its elastic modulus similar to that of human bone tissue and the pore architectures allowing bone ingrow. The pore architectures not only have influence on the effect of bone ingrowth but also determine the mechanical properties of porous Ti. An ideal pore architecture can be constructed by precise regulating of implicit function parameters of triply periodic minimal surface (TPMS). The Gyroid (G) cell structure was used in this paper. The influences of implicit function parameters of G cell on pore structure characteristics, such as porosity, pore diameter and strut diameter were investigated. The homogeneous pore structures with porosity of about 77% and pore size of 300 (G300) and 500 mu m (G500) were designed. Mimicking the radial gradient structure of natural long bone, the graded G pore structure was constructed. Selective laser melting (SLM) technique was used to fabricate the porous Ti samples. Digital microscope and scanning electron microscopy (SEM) were used to observe the pore architecture characteristics of the SLM-produced porous Ti. It is found that the measured porosities of SLM-produced Ti samples are lower than the designed values. The measured pore sizes are less than the designed values and the measured strut diameters are larger than the designed values. The compression tests were examined. The results show that the elastic modulus of porous titanium of G300 and G500 is 2.04 GPa and 3.12 GPa, respectively, and its maximum compressive strength is 63.5 MPa and 103.5 MPa, respectively. The elastic modulus and maximum compressive strength of porous titanium of gradient pore structure is 6.3 GPa and 186.9 MPa, respectively. These results indicate that the G cell gradient porous Ti is an ideal alternative candidate for bone defect repair in load-bearing sites.

Fractal Research of Pore-Structure in Porous Titanium Fibers

Structure and mechanical characteristics of titanium fiber material with gradient pore architecture

Preparation, Microstructure and Mechanical Properties of Porous Titanium Sintered by Ti Fibres

Effect of Porosity on Compressive Properities of Porous Titanium with Helical Pores Structure

Fractal Analysis and Its Impact Factors on Pore Structure of Artificial Cores Based on the Images Obtained Using Magnetic Resonance Imaging

Experimental research on porous titanium implant fabricated by three-dimensional printing with different sintering temperatures

A Novel Approach to Fabrication of Three-Dimensional Porous Titanium with Controllable Structure

Fabrication and Characterization of Porous Titanium Based on TPMS Structure

Use of X-ray CT imaging to quantitatively analyze the effects of the pore morphology on the tensile properties of CP-Ti L-PBF materials

Effect of Sintering Temperature on Microstructure and Properties of Porous Titanium

Effect of Microstructure on the Tensile Property of Porous Ti Produced by Powder Metallurgy Technique

Strength Properties of a Porous Titanium Alloy Ti6Al4V with Diamond Structure Obtained by Laser Power Bed Fusion (LPBF)

Pore-throat structure characterization of carbon fiber reinforced resin matrix composites: Employing Micro-CT and Avizo technique

Fractal Characterization of Pore System Evolution in Cementitious Materials

Flexural and compressive mechanical behaviors of the porous titanium materials with entangled wire structure at different sintering conditions for load-bearing biomedical applications.

Nano-CT Study on Nanostructure of Porous Ceramics

PORE STRUCTURE RECONSTRUCTION AND MOISTURE MIGRATION IN POROUS MEDIA

On the Modelling of Heat and Fluid Transport in Fibrous Porous Media: Analytical Fractal Models for Permeability and Thermal Conductivity

Research on the Permeability of Porous Graphite Based on the Fractal Theory

Quantitative Characterization Of Pore Configuration In A Porous Ni50.8 At.%-Ti Sma