Abstract:The non-contact electrical resistivity method was employed to investigate the microstructural development of three grades of cement under a fixed water-to-cement ratio (w/c) and the same curing conditions. The method was verified by measuring the heat of hydration and estimating the degree of hydration of the three pastes. The results showed that the existence of a linear relationship between the compressive strength at 28 d (f 28) and bulk electrical resistivity at 72 h (ρ72); thus, the proposed method can be used to assess the strength of cement. Moreover, the results indicated that the quality of cement can be further distinguished by interpreting the trend in the resistivity curve. The high-strength cement will have lower electrical resistivity values during cement dissolution due to the higher content of ions in the pore solution, while it will have higher resistivity values during cement hardening due to the greater amount of hydrates. The electrical resistivity of the cement solution (ρ0) filtered from the cement paste at an early age was measured to demonstrate the effect of the ionic concentration on the bulk electrical resistivity in the initial hydration period. The measured liquid resistivity of cement can be used as an indication of clinker reactivity; higher-strength cement will always have lower measured values. The rate of electrical resistivity development curve was plotted to elucidate the setting range of cement pastes based on three critical points. The time at the second critical point (C2) coincided with the final setting time determined using a Vicat needle. New general relationships between the gel-space ratio and electrical resistivity were developed. Furthermore, autogenous shrinkage was measured for the three cement pastes, and the behaviour could be anticipated from the electrical resistivity measurements.

Penetration Resistance and Electrical Resistivity of Cement Paste with Superplasticizer

Influence of Superplasticizers on Early Age Drying Shrinkage of Cement Paste with the Same Consistency

Influence of Superplasticizer Type and Dosage on Early-age Drying Shrinkage of Cement Paste with Consideration of Pore Size Distribution and Water Loss

The Early-Age Drying Shrinkage of Cement-Based Materials with the Same Workability after Temperature Compensation

The Early Hydration Characteristics of Portland Cements with Superplasticizer Using Electrical Measurements

Hyperbolic Method to Analyze the Electrical Resistivity Curve of Portland Cements with Superplasticizer

Monitoring the Setting and Hardening Behaviour of Cement Paste by Electrical Resistivity Measurement

Selection of Superplasticizer in Concrete Mix Design by Measuring the Early Electrical Resistivities of Pastes

Effect of Polycarboxylate Superplasticizer on Cement Hydration by Electrical Resistivity

Evaluation of the Influence of A Superplasticizer on the Hydration of Varying Composition Cements by the Electrical Resistivity Measurement Method

Early Strength Development and Hydration of Cement Pastes at Different Temperatures or with Superplasticiser Characterised by Electrical Resistivity

Interaction Between Superplasticizer and Cement by Electrical Resistivity Method

Critical Features of Microstructure Development of Early-Age Cement Paste Revealed by Non-Contact Electrical Resistivity Measurement

The Electrical Resistivity of Cement Paste Incorporated with Retarder

Investigation of the Early-Age Microstructural Development of Hydrating Cement Pastes Through Electrical Resistivity Measurements

The Influence of Rheological Parameters of Cement Paste on the Dispersion of Carbon Nanofibers and Self-Sensing Performance

Relationship Between Chemical Shrinkage and Electrical Resistivity for Cement Pastes at Early Age

Rheological Behaviors of Fresh Cement Pastes with Polycarboxylate Superplasticizer

Superplasticizer Dosage Effect on Strength, Microstructure and Permeability Enhancement of Cementitious Paste Fills

Effect of Temperature on the Electrical Resistivity of Portland Cement Pastes

Portland Cement Hydration by Electrical Resistivity Method and Computer Simulation