Abstract:Quality of optical signal can be severely degraded after a long distance optical fiber transmission, therefore all-optical 2R (re-amplification, re-shaping) regeneration is required for its low power consumption and good potential of high-speed operation. Semiconductor optical amplifier (SOA) is a very promising candidate for regeneration due to its relatively low nonlinear switching power threshold and possibility of integration. However, speeds of the existing 2R schemes based on SOAs are limited by pattern effects introduced by the long carrier recovery time. So far, most of experimental results for SOA-based regeneration schemes have been limited to 40 Gb/s, only a few demonstrations at 80 Gb/s are available. An effective method to cope with the pattern effects in the SOA is to employ cross gain compression (XGC) effect. Simultaneously injecting two signals of different wavelengths with complementary logics and balanced powers into the SOA leads to an almost constant ability to make the XGC effect intrinsically immune to the pattern effects. Previously, 2R experimental results were demonstrated at 10 Gb/s and 40 Gb/s with XGC respectively, but no further results of higher speed have been presented to date. In this study, we improve the previous two-stage configuration for XGC-based regeneration by introducing a transient cross phase modulation (T-XPM) in the first SOA for generating the high-quality logic-inverted signal, which, as we find, is essential to facilitating the high-speed XGC operation in the next SOA. Firstly, a numerical model of the photon-electron dynamics in an SOA is built with considering the ultrafast intra-band processes, amplified spontaneous emission (ASE) noise at multiple wavelengths, and device segmentation along propagation direction. The quality of the logic-inverted signal with different offsets of the filter wavelength for T-XPM is studied with the model. It is found that the appropriate blue-shift detuning of the filter wavelength greatly helps to improve the quality of the logic-inverted signal. In experiment, the influence of the filter offset on the quality of the logic-inverted signal is also investigated systematically and the best quality and the largest eye-opening of the logic-inverted signal are achieved with a blue-shift of 0.72 nm, which are consistent with the simulation result. With the best logic-inverted signal, XGC effect is deployed in the second SOA. Effective reduction of the amplitude fluctuation can be observed by comparing the eye diagrams of the input degraded with output regenerative signals. Bit error rates (BERs) are also measured for all four tributaries of the degraded and the regenerated signals and the receiving sensitivity at a BER of 10-9 is improved by 1.7-2 dB. Such results show that the XGC-based 2R regeneration scheme is effective even at a speed of as high as 100 Gb/s with the help of high-quality logic-inverted signal. Degraded signals at different wavelengths (from 1535 nm to 1555 nm) are successfully regenerated with Q-factor improvement, demonstrating the wavelength-independent regeneration capability of the XGC-based 2R regenerator.

40‐Gb/s All‐optical 3R Regeneration Based on AFL and SOA‐DI

40-Gb/s all-optical 3R regeneration with semiconductor devices

Demonstration of Two Efficient Optical 3R Data Regenerators at 40 Gb/s Using EAM or SOA As All-Optical Decision Gate

Low timing jitter 40 Gb/s all-optical clock recovery based on an amplified feedback laser diode

Amplified Feedback DFB Laser for 40gb/s All-Optical Clock Recovery

Optical 3R regeneration of 40Gbit/s degraded data signals

All-Optical Clock Recovery for 20 Gb/s Using an Amplified Feedback DFB Laser

Amplified feedback DFB laser for 40 Gb/s all-optical clock recovery

200 Gb/s Optical-Amplifier-Free IM/DD Transmissions Using a Directly Modulated O-Band DFB+R Laser Targeting LR Applications

40Gbits/s All-Optical Clock Recovery for Degraded Signals Using an Amplified Feedback Laser

All-optical 3R regeneration for DPSK signal based on a semiconductor optical amplifier scheme

1000 Cascaded Stages of Optical 3r Regeneration with Soa-Mzi-Based Clock Enhancement to Achieve 10-Gb/s 125.000-Km Dispersion Uncompensated Transmission

Application of a passively mode-locked quantum-dot Fabry-Perot laser in 40 Gb/s all-optical 3R regeneration

A Study of 100 Gb/s 2R Regeneration for Return-to-zero Code Signal

Optical Clock Recovery and 3R Regeneration for 10-Gb/s NRZ Signal to Achieve 10 000-hop Cascadability and 1 000 000-km Transmission

100-Gb/s 2R Regeneration Using Cross Gain Compression in Semiconductor Optical Amplifiers.

High-Performance Optical 3R Regeneration for Scalable Fiber Transmission System Applications

A Study on the Wavelength Conversion and All-Optical 3R Regeneration Using Cross-Absorption Modulation in a Bulk Electroabsorption Modulator

All-optical frequency multiplication/recovery based on the semiconductor optical amplifier ring cavity

Demonstration of Optical 3r Regenerator for 10 Gb/S Nrz Signal in Reconfigurable Recirculating Loop Transmission