Abstract:This paper proposes and demonstrates a simulation model to systematically investigate jitter accumulations in cascaded all-optical 2R regenerators. The simulation results indicate that when the pattern dependence from the memory effect is minimized, the jitter accumulation depends critically on the degree of the regenerative nonlinearity. Studies of tradeoffs between the jitter from bandwidth limitation and the signal-to-noise-ratio degradation help identify the optimized regenerator bandwidth for various degrees of regenerative nonlinearity. The simulation then considers the pattern dependence from the memory effect and finds that it can severely degrade the cascadability of an optical 2R regenerator and can make it worse than that of a linear optical amplifier (optical 1R). The simulation results show good matches to the experimental results of an optical 2R regenerator based on a semiconductor optical amplifier based Mach-Zehnder interferometer. To overcome the jitter accumulation associated with the optical 2R regeneration, we experimentally demonstrate an optical 3R regenerator for optical nonreturn-to-zero signals with all-optical clock recovery. The experiments achieve more than 1000-hop cascadability for pseudorandom binary sequence 2 31 -1 inputs with a 100-km recirculation loop using lab fiber. Field trial experiments then demonstrate a more than 1000-hop cascadability for a 3R spacing of 66 km and a 100-hop cascadability for a 3R spacing of 264 km.

Optical Clock Recovery and 3R Regeneration for 10-Gb/s NRZ Signal to Achieve 10 000-hop Cascadability and 1 000 000-km Transmission

1000 Cascaded Stages of Optical 3r Regeneration with Soa-Mzi-Based Clock Enhancement to Achieve 10-Gb/s 125.000-Km Dispersion Uncompensated Transmission

Demonstration of Optical 3r Regenerator for 10 Gb/S Nrz Signal in Reconfigurable Recirculating Loop Transmission

Cascadability of Optical 3R Regeneration for NRZ Format Investigated in Recirculating Loop Transmission Over Field Fibers

10 000-Hop Cascaded In-Line All-Optical 3R Regeneration to Achieve 1 250 000-Km 10-Gb/s Transmission

All-Optical, Bit-Rate Tunable Clock Recovery For Nrz-Ask Signals

Experimental Demonstration Of An All-Optical Clock And Data Recovery Technology For 10 Gb/S Nrz-Dpsk Signals

High-Performance Optical 3R Regeneration for Scalable Fiber Transmission System Applications

Demonstration of Field Trial Experiments to Investigate the Cascadability of a 10 Gb/s Optical 3R Regenerator with All-optical Clock Recovery

Nanosecond guard time packet-by-packet burst-mode optical 3R regeneration in an optical-label switching router

All-optical 3R regeneration using a single fiber-optical parametric oscillator with idler feedback control circuit

All-optical 3R Regeneration in Monolithic SOA-MZI to Achieve 0.4 Million Km Fiber Transmission

Low-Phase-Noise Clock Recovery from NRZ Signal and Simultaneous NRZ-to-RZ Format Conversion

Optical Regenerative NRZ to RZ Format Conversion Based on Cascaded Lithium Niobate Modulators.

Optical 3R regeneration of 40Gbit/s degraded data signals

Optical clock recovery with dual-wavelength output from degraded RZ and NRZ signals

All-Optical Clock Recovery From 40 Gbit/S Rz Signal Based On Microring Resonators

A Novel Optical Picosecond-Duration NRZ-to-RZ Format Converter with Simultaneous Wavelength Multicasting Using a Single-Stage Mach–Zehnder Modulator

40‐Gb/s All‐optical 3R Regeneration Based on AFL and SOA‐DI

40-Gb/s all-optical 3R regeneration with semiconductor devices

Jitter and Amplitude Noise Accumulations in Cascaded All-Optical Regenerators

Optical Clock Recovery and 3R Regeneration for 10-Gb/s NRZ Signal to Achieve 10&#8201;000-hop Cascadability and 1&#8201;000&#8201;000-km Transmission