Abstract:Currently, the development of industrial waste recycling processes that reduce the anthropogenic load on the biosphere and ensure the rational use of natural resources is an urgent task. Technogenic waste from ferrochrome production contains chromium, which is one of the most toxic components of industrial waste. To extract chromium from them, the most acceptable method is acid leaching. The purpose of the work is to study the influence of temperature, process duration and H2SO4 concentration on the extraction of chromium from high-carbon ferrochrome slag into a sulfuric acid solution. Using mathematical planning of a 3-factor experiment, experiments were carried out to extract chromium from the slags of high-carbon ferrochrome production. The H2SO4 concentration was varied from 5 to 95% by diluting the concentrated acid. The duration of the process ranged from 10 to 180 minutes at S:L = 1:30, the temperature varied from 22 to 90 °C. Results and discussion. The maximum transition of chromium into acid occurs at a temperature of 76-90 °C and a process duration of 145-180 minutes. The degree of extraction reaches 97.9%. The smallest amount of chromium, about 20 mg/L, passes into the weakly concentrated H2SO4 solution, the degree of leaching is low and equal to 20.6%. When using 50% H2SO4, the highest degree of transition of Cr (94.8%) from ferrochrome slag to sulfuric acid occurs at a high temperature of 90 °C in 150-180 minutes. Deeper extraction of chromium cations into acid occurs at 80-90 °C. The maximum content of Cr3+ in the acid is achieved in 46-107 minutes and amounts to (0.33-0.68)%. Conclusions. It was revealed that with increasing process duration and increasing temperature, the degree of extraction increases. The maximum transition of chromium into acid from high-carbon ferrochrome slag occurs at a temperature of 76-90 °C and a process duration of 145-180 minutes. The degree of extraction reaches 97.9%. An increase in the temperature of the process of leaching chromium from VUVC with concentrated sulfuric acid initiates the extraction of chromium from the raw material.

The new technique on separation of Cr and Fe as well as Ni-Co-Mn impurity in leaching sulfate solution of ferrochrome alloy

Selective Complex Precipitation for Ferro-Chrome Separation From Electroplating Sludge Leaching Solution

Selective removal of chromium from laterite residue with high content of iron by the co-operation of phosphoric acid and oxalic acid

Green and Efficient Utilization of Ferruginous Gibbsite Ore and Ferruginous Manganese Ore by Synergetic Carbothermic Co-Reduction–Magnetic Separation Process

Efficient immobilization and utilization of chromite ore processing residue via hydrothermally constructing spinel phase Fe2+(Cr3+X, Fe3+2-x)O4 and its magnetic separation

Co-extraction of Vanadium Titanium and Chromium from Vanadium Slag by Oxalic Acid Hydrothermal Leaching with Synergy of Fe Powder

Effective separation of Zn, Fe, and Mn from roasting-water leaching solution of blast-furnace dust using a precipitation-solvent extraction process

Differential Removal of Copper and Iron from Acidic Polymetallic Aqueous Solutions

Selective extraction performance of Ni, Cu, Co, and Mn adopted by a coupled leaching of low-grade Ni-sulfide ore and polymetallic Mn-oxide ore in sulphuric acid solutions

Near-complete recycling of real mix electroplating sludge as valuable metals via Fe/Cr co-crystallization and stepwise extraction route

An unconventional approach for the efficient recovery of iron, cobalt, copper and silicon from copper slag

Efficient removal and transformation of Cr(VI) from alkaline wastewater to form a ferrochromium spinel multiphase via a modified ferrite process

Use of ferric salt solutions as leaching agents of Co, Ni, Cu, Fe, and Mn from metallic alloys of spent lithium-ion batteries and separation of iron from the leaching solution

A novel method for effective solidifying chromium and preparing crude stainless steel from multi-metallic electroplating sludge

The Separation and Enrichment of Nickel from Leachate of Nickeliferous Laterite by Using Sulfate Crystallization

Removal and recycling of hexavalent chromium from alkaline wastewater via a new ferrite process to produce the valuable chromium ferrite

An Innovative Technique for Comprehensive Utilization of High Aluminum Iron Ore via Pre-Reduced-Smelting Separation-Alkaline Leaching Process: Part I: Pre-Reduced-Smelting Separation to Recover Iron

Chromium and iron recovery from hazardous extracted vanadium tailings via direct reduction magnetic separation

Efficiently Selective Extraction of Iron (III) in an Aluminum‐based Metal‐organic Framework with Native N Adsorption Sites

Recovery of Pure Co(II) and Ni(II) Solutions from Synthetic Sulfate Leach Liquor of Laterite Ores by Precipitation and Solvent Extraction

EXTRACTION OF CHROME FROM FERROCHROME PRODUCTION SLAG USING THE SULFURIC ACID METHOD