Abstract:Abstract The residual stress has significant effects on the microstructure and service performance of films. With good toughness and low stacking fault energy, high-entropy alloy (HEA) can act as dopant to reduce the residual stress of films via self-plastic deformation. Nevertheless, the microscopic mechanism buried deep under the surface is difficult to study by experiments and the dynamic evolution cannot be observed, which the biggest obstacle to investigate the corresponding solutions is. In this paper, diamond-like carbon (DLC) models with different CoCrFeNi HEA doping ratios (1:2, 1:4, 1:6, and 1:8) were designed by molecular dynamics method. The effects of CoCrFeNi doping percentage on the structure and residual stress of this heterostructured films were investigated, and the mechanism of residual stress reduction was revealed. The results show that the phase transformation of HEA causes stress fluctuations in DLC films. The stress fluctuations at different orientations of the heterostructured films is gradually shifted to the right with the increase of HEA percentage, and the difference in stress level between the initial and final strain is significantly decreased. Meanwhile, when the doping ratio is 1:2, the compressive stresses inside the films is lower and the generation of stacking faults is later. With the increase of the HEA doping ratio, the proportion of C atoms with sp 3 and sp 2 hybridization structures is decreased significantly, and the percentages of the distorted C–C bond length and distorted C–C-C bond angle are also reduced. Therefore, HEA doping affects the number of hybrid atoms and the distribution of bond characteristics in DLC films, which leads to the decrease of the residual stress of the heterostructured films. Graphical Abstract

Ab initio molecular dynamics simulation on stress reduction mechanism of Ti-doped diamond-like carbon films

Comparing Internal Stress in Diamond-Like Carbon Films with Different Structure

Existence state of Ti in diamond-like carbon coatings and its effects on hybrid structure and residual stress: Molecular dynamics simulations

Effects of Applying Stress on the Electron Field Emission Properties in Amorphous Carbon Thin Films

Impact of temperature on residual stress and bonding in diamond-like carbon film: A molecular dynamics study under various deposition conditions

Annealing Effect on Microstructure of Novel Ti Doped DLC Multilayer Films

Microstructural And Stress Properties Of Ultrathin Diamond-Like Carbon Films During Growth: Molecular Dynamics Simulations

Atomic insights on nanoindentation-induced plastic-deformation behavior of tetrahedral amorphous carbon film

Role of TiC nanocrystalline and interface of TiC and amorphous carbon on corrosion mechanism of titanium doped diamond-like carbon films: Exploration by experimental and first principle calculation

Research Progress of Metal Doped Diamond-like Carbon Films

Preparation and Tribological Properties of DLC/Ti Film by Pulsed Laser Arc Deposition

Unusual Stress Behaviour of CeO2-doped Diamond-Like Carbon Nanofilms

Residual Stresses And Debonding Of Diamond Films On Titanium Alloy Substrates

Influence of methane flow ratios on the structural and mechanical properties of Ti-doped diamond-like carbon films

Molecular Dynamics Simulation of the Growth and Structural Properties of Ultra-Thin Diamond-Like Carbon Films

Deformation mechanisms of Si-doped diamond-like carbon films under uniaxial tension conditions

Probing the friction mechanism of diamond-like carbon films in aqueous environments based on molecular dynamics simulations

A study of the wear mechanism of diamond-like carbon films

The diagnostic utility of autoantibodies in adult and juvenile myositis

Effects of melting temperature on mechanical properties and bond structures of DLC Films: A molecular dynamic simulation

Atomic insight into residual stress and microstructure evolution of amorphous carbon heterostructured films induced by multi-stage phase transformation of high-entropy alloys