Abstract:Polyvinylidene fluoride (PVDF)–perfluorosulfonic acid (PFSA) blend hollow fiber ultrafiltration (UF) membranes were prepared by wet-spinning method using pure water as an external coagulation solution. Coagulation kinetics of PVDF–PFSA–DMAc system was measured by light transmittance experiment. Using PEG10000 (Mw=10,000), lysozyme (Mw=14,400), PEG20000 (Mw=20,000) and BSA (Mw=67,000), the separation performances of PVDF–PFSA blend hollow fiber UF membranes were obtained. Based on the experimental results, the delayed demixing process was observed for the dope solution M-1 without PFSA-H while the instantaneous demixing process was observed for the others with PFSA-H in the dope solutions M-2 to M-6. The precipitation rate increased with the increment of the PFSA-H concentration in PVDF–PFSA dope solution. The bore fluid solution with 95:5 DMAc:H2O resulted in single finger-like voids for PVDF–PFSA-H UF membrane. The pure water permeation flux of PVDF–PFSA-H UF membranes firstly increased from <0.1×10−5 to 119.1×10−5Lm−2h−1Pa−1 (<0.1 to 119.1Lm−2h−1bar−1) for M-1 to M-4(1) and 137×10−5Lm−2h−1Pa−1 (137Lm−2h−1bar−1) for M-4(2), and decreased from 119.1×10−5 to 79×10−5Lm−2h−1Pa−1 (119.1 to 79Lm−2h−1bar−1) for M-4(1), M-5 and M-6 as the PFSA-H concentration changed from 0% to 5% and total PVDF–PFSA-H concentration was 20wt.%. The molecular weight cut-off (MWCO) of PVDF–PFSA blend hollow fiber UF membranes spun from 20wt.% PVDF–PFSA-H concentration with 3–5wt.% PFSA-H was about 20,000 while that spun from 22wt.% PVDF–PFSA-H or PVDF–PFSA-Na concentration with 5wt.% PFSA-H or PFSA-Na was about 10,000. As the WPFSA-H/WPVDF increases from 2/18 to 5/15 for M-3–M-6, JBSA/Jw increases from 0.53 to 0.79. The anti-fouling property of PVDF–PFSA-H blend UF membrane is superior to PVDF–PFSA-Na blend membrane. Based on FTIR spectra, PFSA-H existed in PVDF–PFSA blend hollow fiber UF membranes. There is no obvious variation of the intensity of the characteristic peak at 983cm−1 assigned to C–O–C group of PFSA-H molecules. This also illustrated that PVDF–PFSA-H blend hollow fiber UF membranes were stable.

PSF hollow fiber membrane fabricated from PSF–HBPE–PEG400–DMAc dope solutions via reverse thermally induced phase separation (RTIPS) process

Fabrication of Hydrophilic and Sponge-Like PVDF/brush-like Copolymer Blend Membranes Using Triethylphosphate As Solvent

Preparation and Characterization of PSf Hollow Fiber Membrane from PSf–HBPE–PEG400–NMP Dope Solution

Construction of membrane formation system with low critical solution temperature for preparing hydrophilic polysulfone membrane via modified reverse thermally induced phase separation process

Preparation of High Density Polyethylene/polyethylene- Block -Poly(ethylene Glycol) Copolymer Blend Porous Membranes Via Thermally Induced Phase Separation Process and Their Properties

Modification of Polysulfone Hollow Fiber Ultrafiltration Membranes Using Hyperbranched Polyesters with Different Molecular Weights

Structure and Properties of PSf Hollow Fiber Membranes with Different Molecular Weight Hyperbranched Polyester Using Pentaerythritol as Core

A Polyethersulfone–bisphenol Sulfuric Acid Hollow Fiber Ultrafiltration Membrane Fabricated by a Reverse Thermally Induced Phase Separation Process

Polysulfone Membranes Via Thermally Induced Phase Separation

Preparation and Characterization of PSf Microporous Membranes by PSf-DMAc-PEG Systems with Low Critical Solution Temperatures

A Facile Way to Prepare Hydrophilic Homogeneous PES Hollow Fiber Membrane Via Non-Solvent Assisted Reverse Thermally Induced Phase Separation (RTIPS) Method

Preparation and Characterization of Polyethersulfone Microporous Membrane Via Thermally Induced Phase Separation with Low Critical Solution Temperature System

Preparation of Polysulfone Membranes Using Ionic Liquid [c(16)mim][scn] As A Pore-Former and Plasticizer

A Novel PES-TiO2 Hollow Fiber Hybrid Membrane Prepared Via Sol-Gel Process Assisted Reverse Thermally Induced Phase Separation (RTIPS) Method

Fabrication of polysulfone membrane with sponge-like structure by using different non-woven fabrics

Anti-pollution Polyethersulfone/sulfonated Polysulfone (pes/spsf) Membrane with Different Sulfonation Degree by Reverse Thermally Induced Phase Separation (RTIPS) Procedure

Preparation and characterization of PES/CA microporous membranes via reverse thermally induced phase separation process

Study on the Preparation of Hollow Fiber Ultra-filtration Membrane of PSF-SPES Blend

Preparation and characterization of PVDF–PFSA blend hollow fiber UF membrane

Development of hydrophilic PES membranes using F127 and HKUST-1 based on the RTIPS method: Mitigate the permeability-selectivity trade-off

Bimetallic polyphenol networks structure modified polyethersulfone membrane with hydrophilic and anti-fouling properties based on reverse thermally induced phase separation method