Abstract:Good gas permeability is an essential factor for the smooth operation and high performance in the lower part of the blast furnace. Under the present low carbon blast furnace smelting conditions, the coke layer is thinner, and the proportion of the molten metal in the coke layer is significantly higher, resulting in a major reduction in gas permeability, which seriously affects blast furnace operations. Also, the lower thickness of the coke layer weakens the process of solid-liquid carbon dissolution when the molten iron passes through the coke layer, which reduces the carbon content of the molten iron and further deepens the erosion of the refractory by the unsaturated molten iron. The carbon dissolution in the molten iron in a blast furnace core was measured by a high-temperature vacuum wettability test tool that analyzed the interface wetting activity between Fe−C melts with specific carbon mass fraction (3.8%, 4.3%, 4.8%) and 99.9% of high temperatures graphite plates. Besides, the scanning electron microscope (SEM) and energy dispersive spectroscopy (EDS) were used to analyze the graphite substrate’s carburizing morphology and carburizing distances. The results show that, with the increase of carbon content, the interface contact angle becomes bigger. The contact angle decreases with time, and eventually reaches a steady-state during the melting process, and the Fe−C melt with saturated carbon cannot be wet. The scanning electron microscopy analysis shows that a spherical cap-like depression is created by a cross-section of the Fe−C melt and the graphite substrate, and the radius and volume of the depression decrease with increasing carbon content. The study of the EDS scanning analysis shows that the amount of dissolved carbon atoms in the graphite substrate penetrates the Fe−C melt and decreases with increasing initial carbon concentration. The smaller the carburizing effect, the better the wetting is conducive to carbon mass transfer. It is found that by measuring carburizing of the carbon atoms in the graphite substrate into the Fe−C melt by calculating the surface energy reduces the surface energy between the two. Thus, the surface tension decreases and the melt spreads slowly with contact angle gradually decreasing during melting.

Iron Carburization In Co-H-2-He Gases, Part I: Experiment

Iron carburization in CO‐H2‐He gases, Part II: Numerical model

Effect of Temperature on CH4/CO Carburization Process of Hydrogen‐Based Direct Reduced Iron Pellets

Iron Carbidization on Thin-Film Silica and Silicon: A Near-Ambient-Pressure X-ray Photoelectron Spectroscopy and Scanning Tunneling Microscopy Study

A Thorough Theoretical Exploration of the Effect Mechanism of Fe on HCN Heterogeneous Formation from Nitrogen-Containing Char

The role of H2 in Fe carburization by CO in Fischer-Tropsch catalysts

Interface Wetting Behavior Between Iron and Coke During the Carbon Dissolution Process in a Blast Furnace

Experimental Study and Computer Simulation on Multicomponent Diffusion in Multiphase Dispersions During Solid Carburizing of HP40Nb and KHR45A Alloys

Kinetic analysis of iron ore powder reaction with hydrogen—carbon monoxide

Numerical Simulation Study of Co-injection of Pulverized Coal and Hydrogen in the Tuyere-Raceway

Reduction kinetics of iron oxide pellets with H2 and CO mixtures

Effect of carburization protocols on molybdenum carbide synthesis and study on its performance in CO hydrogenation

Difference of Hydrogen Diffusion Regularity Between Interstice-Doped and Substitution-Doped Formed by Steel Carburizing

Effect of reduction and carburization pretreatment on iron catalyst for synthesis of light olefins from CO hydrogenation

Mechanism of Iron Oxide Reduction with Hydrogen/Carbon Monoxide Mixtures·

Competition and Inhibition Effects During Coal Char Gasification in the Mixture of H2o and Co2

Preparation of Iron Carbides Formed by Iron Oxalate Carburization for Fischer–Tropsch Synthesis

Diffusion behavior of carbon and its hardening effect on plasma carburized M50NiL steel: Influences of treatment temperature and duration

An Introductive Study about CO 2 Hydrogenation into Hydrocarbons Using Iron Catalysts

CO2 corrosion of IG-110 nuclear graphite studied by gas chromatography