Abstract:Substructure method has been widely applied in dynamic analysis of complex structures due to high computational efficiency. On the basis of Residual flexibility mixed-boundary (RFMB) substructure method, a model updating approach is proposed in this paper. Four major steps of the RFMB model updating method are summarized as: 1) Substructuring: Dividing the whole structure into residual part and reduced part according to the junction surface; 2) reduction: Using the RFMB component mode synthesis approach to reduce the order of each substructures; 3) assembly: Residual structure analysis by using the reduced assemble matrix; 4) updating: Model updating by solving the optimization problem. Numerical simulation is conducted to verify the effectiveness by adopting a cantilever plate in case I. In case II, the proposed method is applied to identify the elastic parameter of interface of a bolted joint structure using experimental data. After parameter identification, the maximum error between numerical results and the experimental data decreases to 2.44 %. And three component mode synthesis model updating methods: Craig-Bampton (CB), Mixed-boundary (MB) without considering residual flexibility and RFMB model updating approach, are applied to update the same bolted joint structure for comparing the accuracy. For comparing the computational efficiency, the RFMB model updating approach is applied to the complicated aero-engine casing structure. In case III, the average time-consuming of the Whole finite element model (WFEM) is 5.15 times to the Residual finite element model (RFEM) in the single updating iteration. Results show that the proposed approach has better performance in the finite element model updating.

Model Updating of Semirigid Jointed Structure Using Generic Parameters

Bio-based Connections and Hybrid Planar Truss: A Parallel Genetic Algorithm Approach for Model Updating

SUPER-ELEMENT WITH SEMI-RIGID JOINTS IN MODEL UPDATING

An Axial Semi-Rigid Connection Model for Cross-Type Transverse Branch Plate-to-chs Joints

Updating finite element model of structures with semi-rigid joints and boundary

Updating Semi-Rigidity of Joints and Boundary Conditions of Structures Using a Hybrid Finite Element

A DIRECT MODEL UPDATING METHOD USING ADDED KNOWN STIFFNESS

Theoretical research on the energy substructure finite element model updating technology with parametric analysis

Model Updating and Parameters Estimation Incorporating Flexible Joints and Boundary Conditions

Nonlinear Joint Model Updating in Assembled Structures

Dynamical finite element model updating methods by adding known masses

Hybrid Simulation of Steel Frame Structures with Sectional Model Updating

Estimation of Semi-Rigid Joints by Cross Modal Strain Energy Method

Finite Element Model Updating of Complex Structure Using Component Mode Synthesis Technique

Dynamic Model Updating Based on Strain Mode Shape and Natural Frequency Using Hybrid Pattern Search Technique

An updating method suitable for finite element model updating of large-scakled structures

Model Updating Using Substructural Modal Data

Static Finite Element Model Updating for Special-Shaped Bridge Based on Uniform Design Method

Substructure-based model updating using residual flexibility mixed-boundary method

Structural Finite Element Model Updating by Using Response Surfaces and Radial Basis Functions

Model Updating of Complex Structures Using the Combination of Component Mode Synthesis and Kriging Predictor