Abstract:Substructure method has been widely applied in dynamic analysis of complex structures due to high computational efficiency. On the basis of Residual flexibility mixed-boundary (RFMB) substructure method, a model updating approach is proposed in this paper. Four major steps of the RFMB model updating method are summarized as: 1) Substructuring: Dividing the whole structure into residual part and reduced part according to the junction surface; 2) reduction: Using the RFMB component mode synthesis approach to reduce the order of each substructures; 3) assembly: Residual structure analysis by using the reduced assemble matrix; 4) updating: Model updating by solving the optimization problem. Numerical simulation is conducted to verify the effectiveness by adopting a cantilever plate in case I. In case II, the proposed method is applied to identify the elastic parameter of interface of a bolted joint structure using experimental data. After parameter identification, the maximum error between numerical results and the experimental data decreases to 2.44 %. And three component mode synthesis model updating methods: Craig-Bampton (CB), Mixed-boundary (MB) without considering residual flexibility and RFMB model updating approach, are applied to update the same bolted joint structure for comparing the accuracy. For comparing the computational efficiency, the RFMB model updating approach is applied to the complicated aero-engine casing structure. In case III, the average time-consuming of the Whole finite element model (WFEM) is 5.15 times to the Residual finite element model (RFEM) in the single updating iteration. Results show that the proposed approach has better performance in the finite element model updating.

Updating finite element model of structures with semi-rigid joints and boundary

Updating Semi-Rigidity of Joints and Boundary Conditions of Structures Using a Hybrid Finite Element

Model Updating of Semirigid Jointed Structure Using Generic Parameters

SUPER-ELEMENT WITH SEMI-RIGID JOINTS IN MODEL UPDATING

Finite Element Model Updating Method of Bridge Combined Modal Flexibility and Static Displacement

Dynamical finite element model updating methods by adding known masses

An updating method suitable for finite element model updating of large-scakled structures

Model Updating and Parameters Estimation Incorporating Flexible Joints and Boundary Conditions

Nonlinear Joint Model Updating in Assembled Structures

Substructure-based model updating using residual flexibility mixed-boundary method

Study on model updating for a steel frame based on optimization theory and vibration test results

Static and dynamic finite element model updating of structures based on response surface method: theory and application

Application of Model Updating to Bolted Joint Structures

Finite Element Model Updating of Complex Structure Using Component Mode Synthesis Technique

Hybrid Simulation of Steel Frame Structures with Sectional Model Updating

Selective online model updating in hybrid simulation of a full‐scale steel moment frame

An iterative method for updating finite element models with connectivity constraints

Dynamic Model Updating Based on Strain Mode Shape and Natural Frequency Using Hybrid Pattern Search Technique

Substructure Based Approach to Finite Element Model Updating

Model Updating Using Substructural Modal Data

FE Model Updating on an In-Service Self-Anchored Suspension Bridge with Extra-Width Using Hybrid Method