Abstract:In the operating process of the coal-fired generation during flexible peaking regulation, the primary and secondary water droplets in the steam flowing through the last two stages of the low-pressure cylinder could influence the efficiency and safety of the steam turbine definitely. However, systematic analysis of the movement characteristics of water droplets under low-load conditions is scarcely in the existing research, especially the ultra-low load conditions below 30%. Toward this end, the more novel algebraic slip model and particle transport model mentioned in this paper are used to simulate the primary and secondary water droplets. Taking a 600 MW unit as a research object, the droplets motion characteristics of the last two stages were simulated within four load conditions, including 100, 50, 40, and 30% THA. The results show that the diameter of the primary water droplets is smaller, ranging from 0 to 1 μm, during the flexible peak regulation process of the steam turbine. The deposition is mainly located at the entire moving blades and the trailing edge of the last two stator blades. With the load decreasing, the deposition effect decreases sustainably. And the larger diameters of secondary water droplets range from 10 to 300 μm. The erosion of secondary water droplets in the last stage is more serious than that of the second last stage for different load conditions, and the erosion of the second last stage could be negligible. The pressure face and suction face at 30% blade height of the last stage blade have been eroded most seriously. The lower the load, the worse erosion from the secondary water droplets, which poses a potential threat to the fracture of the last stage blades of the steam turbine. This study provides a certain reference value for the optimal design of steam turbine blades under flexible peak regulation.

Coarse Water in Low-Pressure Steam Turbines

Simultaneous Measurements of Fine and Coarse Droplets of Wet Steam in A 330mw Steam Turbine by Using Imaging Method

An Experimental Study of Turbine Vane Film Cooling Using Endoscope-Based PSP Technique in a Single-Passage Wind Tunnel

Research on Water Droplet Movement Characteristics in the Last Two Stages of Low-Pressure Cylinder of Steam Turbine Under Low Load Conditions

Study on water extraction of hollow stationary blade under wet steam flow conditions

Measurements of Droplet Sizes at Mid-hight of Stationary Turbine Blades and Analysis of the Critical Weber Number

Performance Enhancement of an Inline Cross-FLow Hydro Turbine for Power Supply to Water Leakage Monitoring System

Study of the Law Governing the Water Droplet Deposition and Wetness Removal from the Stationary Blades at the Last Stage of a Steam Turbine

Water Droplets Dispersion And Optimization Of Water Removal Suction Slot Locations On Stationary Blades In Last-Stage Of A 600 Mw Steam Turbine

Experimental technique based of an innovative heating method for the wetness measurement of flowing wet steam

Experimental Technique Based on the Use of an Innovative Heating Method for the Wetness Measurement of Flowing Wet Steam

Distribution Characteristics of High Wetness Loss Area in the Last Two Stages of Steam Turbine under Varying Conditions

Water Drop Erosion on Turbine Blades: Numerical Framework and Applications

Influence of Axial Clearance on Flow Field in the Rotor Cascades and Law of Droplet Deposition in a Humidity-Removing Stage

Study of Wet Steam Two-Phase Flow with Condensation in Steam Turbine

Experimental Study on Removal of Water Film from Steam Turbine Stator Blade Surfaces by Suction Slots

Investigations on Aerodynamic Performance and Structural Optimization Design of Nozzle Governing Stage for Large Steam Turbines

Study on the Wet Steam Flow in a Steam Turbine

Analysis of Water Drop Erosion on Turbine Blades Based on a Nonlinear Liquid–solid Impact Model

Experience Measurement of Winter-Kennedy Method on Low Head Tubular Turbine Units

High Pressure Steam-Water Flow and Dryness Measurements with Multihole Probes