Abstract:Assorted morphologies of precipitates in fcc/bcc transformation systems have been reported, which often exhibit irrational characteristic. Various models have been developed to explain the habit plane (or the broad facet), but the overall morphologies of the precipitates are seldom explained quantitatively. In this work, the equilibrium cross-section of rod-shape austenite precipitates in duplex stainless steel is determined by atomistic simulation. The input orientation relationship (OR) between fcc and bcc phase is determined according to the O-line criterion (one of the interfaces contains a single set of dislocations), with the condition that the invariant line lies in close-packed plane pair of (1 (1) over bar(1) over bar)(f)|(10 (1) over bar)(b) and the Burgers vector of O-lines is [011](f|)/2|((1) over bar 11)(b)/2. The obtained OR is close to the K-S OR ((11 (1) over bar)(f)//(01 (1) over bar)(b), [101](f)//(111)(b)), with the deviation of 1.27 degrees from the parallelism in both planes and directions. Interfacial energy of interfaces in various orientations in the zone axis of the invariant line ([0.75 0.10 0.65](f)//[0.52 0.68 0.52](b)) has been calculated. To ensure the reliability of the calculated values, an initial atomic configuration free of interstitial and vacancy is constructed for each interface. The energies of the O-line interface, the interface normal to either Delta g(((1) over bar 11)) or Delta g((020)) are found to have similar values, each at a local minimum. Based on the calculated interfacial energies, the equilibrium cross-section morphology is determined by the Wulff construction. The result shows that the morphology exhibits a near rhombus cross-section, which agrees consistently with experiments. One of the major facets is the O-line interface, normal to ((0.66) over bar 0.12 0.74)(f)//((0.51) over bar (0.24) over bar 0.83)(b), in agreement with the observation. The other facet is normal to Delta g((020)) (((0.25) over bar (0.87) over bar 0.42)(f)//(0.45 (0.73) over bar 0.51)(b)) in the calculated result, while it is normal to Delta g(((1) over bar 11)) (((0.36) over bar (0.77) over bar 0.53)(f)//(0.31 (0.71) over bar 0.63)(b)) in experimental results, with about 10 degrees difference between them. The discrepancy between calculated and observed results is probably because the experiments have not reached the equilibrium state. The dislocation structures in these three interfaces are identified from the atomic simulation results by a newly developed method based on the singular value decomposition of the Nye tensor. It confirms that the O-line interface contains a single set of [011](f)/2 dislocations with spacing of 1.5 nm. The interface normal to either Delta g(((1) over bar 11)) or Delta g((020)) contains two sets of dislocations. The dislocation structure in the facet normal to Delta g((1) over bar 11)) is in good agreement with experimental observation of the non-O-line facet, including the local decomposition of dislocation core to (1 (1) over bar(1) over bar)(f) stacking faults.

Secondary Dislocation Structures in a Ni–TiN System from the GMS and O-lattice Theory

Shearing Mechanisms of Stacking Fault and Anti-Phase-boundary Forming Dislocation Pairs in the Γ′ Phase in Ni-based Single Crystal Superalloy

Calculation of Interfacial Dislocation Structures: Revisit to the O-lattice Theory

Misfit dislocation networks in the γ/γ' phase interface of a Ni-based single-crystal superalloy : Molecular dynamics simulations

Effect of Lattice Misfit on the Evolution of the Dislocation Structure in Ni-based Single Crystal Superalloys During Thermal Exposure

Dislocation description of martensite interfaces based on misfit analysis

Orientation Relationship and Interfacial Structure Between Ζ-Ti5si3 Precipitates and Γ-Tial Intermetallics

Atomic-scale Observation of the Interfaces Between Η and Γ Matrix in ATI718Plus

Misfit Dislocation Networks In The Gamma Broken Vertical Bar Gamma ' Phase Interface Of A Ni-Based Single-Crystal Superalloy: Molecular Dynamics Simulations

Interface reconstruction and dislocation networks for a metal/alumina interface: an atomistic approach

Molecular Dynamics Simulation of Atomic Configurations at Γ/γ′ (001) Interface in Ni-based Single-Crystalline Superalloys

Secondary Coincidence Site Lattice Model for Truncated Triangular Β-Mg2sn Precipitates in a Mg-Sn-Based Alloy

Coincidence structures of interfacial steps and secondary misfit dislocations in the habit plane between Widmanstätten cementite and austenite

Evolution of Interphase Misfit Dislocation Networks in Ni-Based Single-Crystal Superalloy

Atomistic Simulation of Misfit Dislocation in Metal/oxide Interfaces

Atomistic study of ordinary screw dislocations in single-phase and lamellar γ-TiAl

Identification of Secondary Dislocations by Singular Value Decomposition of the Nye Tensor

O-lattice Analyses of Interfacial Misfit. II. Systems Containing Invariant Lines

Lattice instabilities of cubic NiTi from first principles

An Investigation on the Equilibrium Morphology and Interfacial Structures of Pricipitates in Duplex Stainless Steel by Atomistic Simulation

Dislocation Structure of Non-Habit Plane of Α Precipitates in a Ti–7.26 Wt.% Cr Alloy