Abstract:Co‐current flow is chosen to represent the collective performance of all flow patterns; A trade‐off between the purity of CO2 and the recovery factor is observed; Despite the reduction of purity, a higher amount of CO2 can be recovered with a larger membrane area; A sharp decline in power requirement is observed with increasing selectivity from 2 to 20. Direct air capture (DAC) of CO2 is becoming increasingly important for reducing greenhouse gas concentrations in the atmosphere. However, the cost and energy requirements associated with DAC make it less economically feasible than carbon capture from flue gases. While various methods like solid sorbents and gas–liquid absorption have been explored for DAC, membrane processes have only recently been investigated. The objective of this study is to examine the separation performance of a membrane unit for capturing CO2 from ambient air. The performance of a membrane depends on several factors, including the composition of the feed gas, pressure ratio, material selectivity, and membrane area. The single‐stage separation process with the co‐current flow and constant permeability flux model is evaluated using a commercial module integrated with a process simulator to separate a binary mixture of carbon dioxide and nitrogen to assess the sensitivity of selectivity on purity and recovery of CO2 in permeate, and power requirement. Additionally, three levels of CO2 reduction from the feed stream to the retentate stream (25%, 50%, and 75%) are studied. A trade‐off between purity and recovery factor is observed, and achieving high purity in permeate requires high concentration in the retentate.

Electrochemical Capture of CO2from Natural Gas Using a High-Temperature Ceramic-Carbonate Membrane

Electrochemical Separation of CO2 from a Simulated Flue Gas with High-Temperature Ceramic–carbonate Membrane: New Observations

Post-combustion CO2 capture from a natural gas combined cycle power plant using activated carbon adsorption

High Co2 Permeation Flux Enabled By Al(2)O(3) Modifier And In-Situ Infiltration Of Molten Carbonate Into Gd-Doped Ceo2 As A Co2 Separation Membrane

Understanding the performance of membrane for direct air capture of CO2

A High-Permeance Supported Carbon Molecular Sieve Membrane Fabricated by Plasma-Enhanced Chemical Vapor Deposition Followed by Carbonization for Co2 Capture

Synthesis and Characterization of Gadolinium Doped Ceria-Carbonate Dual-Phase Membranes for Carbon Dioxide Separation

High CO2 permeability of ceramic-carbonate dual-phase hollow fiber membrane at medium-high temperature

Superhydrophobic Ceramic Membrane Coupled with a Biphasic Solvent for Efficient CO2 Capture

Oxy-Fuel Combustion for Co2 Capture Using A Co2-Tolerant Oxygen Transporting Membrane

Modeling of CO2 Mass Transport Across a Hollow Fiber Membrane Reactor Filled with Immobilized Enzyme

CO2 capture using superhydrophobic ceramic membrane: Preparation and performance analysis

Ultrahigh permeation of CO2 capture using composite organosilica membranes

A layered perovskite La1·5Sr0·5NiO4±δ-molten carbonate dual-phase membrane for CO2 capture from simulated flue gas

Sulfonated Chitosan Gel Membrane with Confined Amine Carriers for Stable and Efficient Carbon Dioxide Capture

Oxygen Separation Through U‐shaped Hollow Fiber Membrane Using Pure CO2 As Sweep Gas

Simulation of the Membrane Process of CO2 Capture from Flue Gas via Commercial Membranes While Accounting for the Presence of Water Vapor

Progress and Perspectives in the Development of Inorganic-Carbonate Dual-Phase Membrane for CO2 Separation

High-temperature carbon dioxide capture in a porous material with terminal zinc hydride sites

Removal of CO2 from Simulated Flue Gas of Power Plants by Membrane-Based Gas Absorption Processes

Mixed-Matrix Organo–Silica–Hydrotalcite Membrane for CO2 Separation Part 2: Permeation and Selectivity Study