Abstract:NiO nanomaterials prepared using a solid–liquid NH3·H2O precipitation method (NiO-NSL) were tested in the catalytic combustion of methane. The NiO-NSL presented a characteristic rod-like nanostructure with a length of about a few hundred nanometers except for a part of the nanoparticles. For comparison, the NiO nanomaterials prepared by the traditional liquid-phase NH3·H2O precipitation method (NiO-NLL) were tested in the same reaction conditions. NiO-NSL exhibited significantly higher methane combustion activity than NiO-NLL and achieved the complete combustion of methane at 390 °C, which was outstanding in non-noble metal-based catalyst. X-ray photoelectron spectroscopy (XPS) and hydrogen-temperature-programmed reduction (H2-TPR) results indicate that the surface Ni2+ content of NiO-NSL was higher than that of NiO-NLL, and the presence of more Ni2+ might be responsible for the enhanced activity. DFT calculations prove that the energy barrier for C–H bond activation on Ni2+ was lower than that on Ni3+, which was consistent with the higher methane catalytic combustion activity of NiO-NSL. In addition, when the precipitating agent was replaced with NaOH and (NH4)2CO3, the generalization of the solid–liquid precipitation method in the preparation of the NiO catalysts was also tested. The results show that the solid–liquid precipitation method proposed in this work was still applicable when NaOH was used as a precipitant. However, with the use of (NH4)2CO3 as a precipitant, the methane catalytic activity of the NiO nanoparticles prepared by the solid–liquid precipitation method was reduced to a certain extent compared with the traditional liquid-phase precipitation method. This research can open up a highly efficient and environmentally friendly method for the synthesis of methane combustion catalysts.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acsanm.1c00732?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acsanm.1c00732</a>.Stability test results of NiO-NSL (Figure S1); wide-angle XRD patterns of the as-precipitated samples using (NH4)2CO3 as the precipitant and a standard xNiCO3·yNi(OH)2 sample (Figure S2); representative TEM images of the precursors and as-calcined catalysts of the other four samples (Figures S3 and S4); specific performance data of samples in previous research (Table S1); XPS analysis of the other samples (Table S2, Figures S5 and S6); H2-TPR profiles of the other samples (Table S3, Figures S7 and S8); detailed DFT calculation results (Table S4); the surface model used in the calculations (Figure S9) (<a class="ext-link" href="/doi/suppl/10.1021/acsanm.1c00732/suppl_file/an1c00732_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Na Promoted Ni/γ-Al2O3 Catalysts Prepared by Solution Combustion Method for Syngas Methanation

The Effect of Na Promoter on Fe-Based Catalyst for CO2 Hydrogenation to Alkenes

Ni–Al2O3 Catalysts Prepared by Solution Combustion Method for Syngas Methanation

Mn and Mg Dual Promoters Modified Ni/α-Al2O3 Catalysts for High Temperature Syngas Methanation

Methanation of CO 2 over Y b-Promoted Ni/Al 2 O 3 Catalysts Prepared by Solution Combustion

Impact of Heating Rate and Solvent on Ni-based Catalysts Prepared by Solution Combustion Method for Syngas Methanation

Partial Oxidation Of Methane To Syngas Over Ni-Based Catalysts

Insights into the Zn Promoter for Improvement of Ni/SiO 2 Catalysts Prepared by the Ammonia Evaporation Method toward CO 2 Methanation

Effect of La, Mg and Mo Additives on Dispersion and Thermostability of Ni Species on Kit-6 for Co Methanation

Highly efficient NiAl 2 O 4 -free Ni/γ-Al 2 O 3 catalysts prepared by solution combustion method for CO methanation

Solution-combusted nanosized Ni–Al2O3 catalyst for slurry CO methanation: effects of alkali/alkaline earth metal chlorides

Promoter Impact on 5Ni/SAPO-5 Catalyst for H2 Production via Methane Partial Oxidation

Plasma‐Catalytic CO2 Methanation Over Supported Ni–Co Catalysts Prepared by Solution Combustion Synthesis

High-Stability ZnAl2O4 Spinel-Supported Nickel Catalyst for High-Temperature Syngas Methanation

Ni-CeO2 Catalyst with High Ni Loading Prepared by Salt-Assisted Solution Combustion for CO2 Methanation

Synthesis and Characterization of Well Dispersed Nickel-Incorporated SBA-15 and Its High Activity in Syngas Methanation Reaction

Catalytic Methanation of Syngas over Ni-based Catalysts with Different Supports

Addition of Sodium Additives for Improved Performance of Water-Gas Shift Reaction over Ni-Based Catalysts

Enhanced CO2 Methanation over Ni/Na-HNTs: Effect of Pretreatment with NaOH

Irregularly Shaped NiO Nanostructures for Catalytic Lean Methane Combustion

Catalytic Partial Oxidation of Methane to Syngas over Ca-Decorated-Al2o3-Supported Ni and Nib Catalysts