Abstract:The insulation condition is the key to determining whether gas insulated switchgears (GISs) can operate stably and reliably. Partial discharge (PD) detection is an important technique for condition monitoring and evaluation in GIS. Acoustic emission (AE) method is commonly used in on-site PD detection. However, in field applications, there are often problems such as low signal-to-noise ratio (SNR) of measured ultrasonic signals and difficulty in extracting PD pulses. To solve this problem, a denoising method for GIS ultrasonic signals based on the combination of ultrasonic and ultra-high frequency (UHF) signals is proposed in this paper. Based on the difference in correlation between noise and PD signals, the noise in measured signal can be suppressed through accumulating and averaging of multiple ultrasonic signals, and the SNR of PD signal can be significantly improved. An actual 500-kV GIS experiment platform is established, and PD measurements for different types of defects are conducted. Then, a comparative study is conducted on the denoising performance of the proposed method and traditional denoising methods such as wavelet method and singular value decomposition (SVD) method. The results indicate that compared to traditional methods, the method proposed in this paper has a higher reduction in noise level. Especially for extremely low-SNR signals (PD pulses buried in noise), traditional methods have poor performance, while the proposed method can still extract the PD pulse form the noise. Furthermore, based on the denoised ultrasonic signals, the defect localization analysis is conducted to demonstrates the correctness of the denoising results. Finally, the proposed method is applied to on-site PD detection, which further evaluates the effectiveness of the denoising method.

Estimation of Time Difference Between Partial Discharge Uhf Signals Using Differential Energy Method

Discrimination of Three or More Partial Discharge Sources by Multi-Step Clustering of Cumulative Energy Features

Location of PD by Searching in Space Using UHF Method

Multi-Source Partial Discharge Fault Location with Comprehensive Arrival Time Difference Extraction Method and Multi-Data Dynamic Weighting Algorithm

Partial Discharge Direction of Arrival Estimation in Air-insulated Substation by UHF Wireless Array and RSSI Maximum Likelihood Estimator

Comparison of Different Time-Frequency Analysis Methods for Sparse Representation of PD-induced UHF Signal

Relationship Between Time-Frequency Representation of PD-induced UHF Signal and PD Current Pulse

Partial discharge location of power cables based on an improved single-terminal method

Research on Time Delay Estimation Method of Partial Discharges Signal with Improved Weighted Function

Minimally invasive nephron‐sparing surgery for renal cell cancer

Research on the Typical Partial Discharge Using the UHF Detection Method for GIS

Field test on a transformer for partial discharge location by uwb-rf method

Application to Real Power Networks of a Method to Locate Partial Discharges Based on Electromagnetic Time Reversal

Uneven Demagnetization Fault Diagnosis in Dual Three-Phase Permanent Magnet Machines Based on Electrical Signal Difference

Time–frequency Analysis of PD-induced UHF Signal in GIS and Feature Extraction Using Invariant Moments

Electromagnetic time reversal for online partial discharge location in power cables: Influence of interfering reflections from grid components

A New Method for Arrival Time Determination of Impact Signal Based on Hht and Aic

Investigation of the Evaluation of the Pd Severity and Verification of the Sensitivity of Partial-Discharge Detection Using the Uhf Method in Gis

Experimental Investigation on High Frequency Sensing Characteristis of Floating Type Partial Discharge

A Denoising Method for Partial Discharge Ultrasonic Signals in GIS Based on Ultra-High Frequency Signal Synchronization

Partial discharge localisation in transformers using UHF technique: non-iterative method