Abstract:In this paper, a novel MEMS accelerometer with tuned quasi-zero stiffness stabilized and operated in a closed-loop is proposed. By using the electrostatic softening effect of the double-sided comb-finger capacitors and the triangular capacitors, the effective stiffness of the accelerometer can be adjusted to quasi-zero. The variation of the electrostatic stiffness arising from the thermal drift of the proposed quasi-zero stiffness accelerometer can be greatly reduced when utilizing the double-sided comb-finger capacitors. For a high-sensitivity and high-linearity acceleration measurement, a traditional proportional-integral-derivative (PID) controller and a proportional-integral sliding mode (PISM) controller are designed for the stabilization near the border of pull-in. The parameters of the controller are tuned to ensure that the proof mass is stably positioned at the desired position. Both the simulation and experiment validate the feasibility of two controllers, showing distinct transient characteristics and long-term stability performance. Compared to the open-loop accelerometer with untuned stiffness, the sensitivity of the closed-loop accelerometer is increased over 40 times while the long-term stability of the closed-loop accelerometer with quasi-zero stiffness is remarkably improved for both controllers. The PID-controlled accelerometer with quasi-zero stiffness has an Allan bias instability as low as 22.51 ng and narrow bandwidth of 0.36 Hz. The PISM controlled accelerometer with quasi-zero stiffness has a linearly varied Allan bias instability from 37 ng to $2.02 ~\mu \text{g}$ depending on the switching gain which determines the acceleration input range. However, the bandwidth of the PISM control system exhibits a nonlinear and wide-range variation with respect to the switching gain.

Elimination of nonlinearity in sigma delta MEMS accelerometer

Analysis of the Frequency-Dependent Vibration Rectification Error in Area-Variation-Based Capacitive MEMS Accelerometers.

A Stiffness-Tunable MEMS Accelerometer

An In-Plane Low-Noise Accelerometer Fabricated with an Improved Process Flow

Fuzzy Sliding-Mode Control of the Electrostatically Tuned Quasi-Zero Stiffness MEMS Accelerometer.

Design and Test of MEMS Gyroscope Control System Based on LMSD

A Real-Time Temperature Compensation Algorithm for a Force-Rebalanced MEMS Capacitive Accelerometer Based on Resonant Frequency.

Identification and Suppression of Driving Force Misalignment Angle for a MEMS Gyroscope Using Parametric Excitation

Mechanical Design Optimization of A Single-Axis Moems Accelerometer Based on A Grating Interferometry Cavity for Ultrahigh Sensitivity

Temperature Drift Compensation of a Tuned Low Stiffness MEMS Accelerometer Based on Double-Sided Parallel Plates

A Sub-µg Bias-Instability MEMS Oscillating Accelerometer with an Ultra-Low-Noise Read-Out Circuit in CMOS

Design And Implementation Of A Novel Cmos-Mems Single Proof-Mass Tri-Axis Accelerometer

Implementation of A Monolithic Single Proof-Mass Tri-Axis Accelerometer Using Cmos-Mems Technique

A Background Test and Calibration Technique of Nonlinear Mismatches in MEMS Oscillating Accelerometers

A 0.084% Nonlinearity Open-Loop Capacitive Micro-Accelerometer with On-Chip Digital Nonlinearity Calibration and Embedded EEPROM

Nonlinearity of a Closed-Loop Micro-accelerometer

Stabilization Control of a MEMS Accelerometer With Tuned Quasi-Zero Stiffness

Modeling and Analysis of a Closed-Loop System for High-Q MEMS Accelerometer Sensor

A Novel Digital Closed Loop MEMS Accelerometer Utilizing a Charge Pump.

A novel SOI-based single proof-mass 3-axis accelerometer with gap-closing differential capacitive electrodes in all sensing directions

3-axis Capacitive Low-Gravity MEMS Accelerometer with Zero Cross-Axis Sensitivity in a Commercial Process