Abstract:This paper covers the development of tensile strain design models using a multidisciplinary approach, including fundamental fracture mechanics, small-scale material characterization tests, and large-scale tests of full-size pipes. The tensile strain design models are formulated in a four-level format. The Level 1 procedure provides estimated tensile strain capacity (TSC) in a tabular format for quick initial assessment. The initiation toughness alternatively termed apparent toughness is estimated from upper shelf Charpy impact energy. The Level 2 procedure contains a set of parametric equations based on an initiation-control limit state. The tensile strain capacity can be computed from these equations with the input of a pipe's dimensional and material property parameters. The apparent toughness is estimated from either upper shelf Charpy energy or upper shelf toughness of standard CTOD test specimens. The Level 3 procedure uses the same set of equations as in Level 2 and the toughness values are obtained from low-constraint tests. In the Level 3 procedure, two limit states based on either initiation control or ductile instability can be used. The Level 4 procedure allows the use of direct FEA calculation to develop crack driving force relations. The same limit states as those in Level 3 may be used. The Level 4 procedures should only be used by seasoned experts in special circumstances where lower level procedures are judged inappropriate.The tensile strain design models may be used for the following purposes:(1) The determination of tensile strain capacity for a given set of material properties and flaw size.(2) The determination of acceptable flaw sizes for a given set of material properties and target tensile strain capacity.(3) The selection of material properties to achieve a target strain capacity for a given flaw size.(4) The optimization of the tensile strain capacity by balancing the requirements of material parameters, such as weld strength (thus weld strength mismatch level) versus toughness.The application of the tensile strain design models is given in a companion paper.

A Quantitative Approach to Tensile Strain Capacity of Pipelines

A study of the ultimate compressive strain of local buckling in strain-based design of pipelines

A Simplified Analytical Solution of Pipeline Response under Normal Faulting

Strain Based Design Of High Strength Pipelines

Tensile Strain Models for Strain-Based Design of Pipelines

Strength Differential Effect and Influence of Strength Criterion on Burst Pressure of Thin-Walled Pipelines

Considerations Of Linepipe And Girth Weld Tensile Properties For Strain-Based Design Of Pipelines

The application of strain-based design to pipelines and the requirements on pipe materials

A Tiered Approach to Girth Weld Defect Acceptance Criteria for Stress-Based Design of Pipelines

Investigation of the tensile strain response of the girth weld of high-strength steel pipeline

Application Of Compressive Strain Capacity Models To Multiple Grades Of Pipelines

Overall Framework Of Strain-Based Design And Assessment Of Pipelines

Numerical study on the strain capacity of girth-welded X80 grade pipes

The Role Of Anisotropy, Toughness Transferability, And Weld Misalignment In The Strain Based Design Of Pipelines

Apparent Fracture Toughness from Constraint Considerations and Direct Testing

Plastic Limit Load Analysis for Pressure Pipe with Incomplete Welding Defects Based on the Extended Net Section Collapse Criteria

Theoretical Assessment of Burst Failure of Internally Pressurized Defect-Free Pipelines with Plastic Anisotropy

Tensile Strain Capacity Of Spiral Pipes

Burst Pressure of Pipelines with Plastic Anisotropy under Combined Internal and External Pressures

Effect of the Y/T on the Burst Pressure for Corroded Pipelines with High Strength

Quantitative research on stress failure risk assessment for girth welds with unequal wall thickness of the X80 pipeline under lateral load