Abstract:In this study, the residual-stress fields around crack tip of M(T) specimens under three single tensile overload ratios (Rol) during fatigue crack growth of aluminum alloy 2524-T3 were investigated using the instrumented indentation tests (IIT). The results showed that both the magnitude and region of the compressive residual stress around the crack tip increase with the increase of Rol. Finite element method was also used to simulate the residual stress distributions near the crack tip at the same loading conditions as experiments, which confirmed that the estimation of the crack-tip residual stress using Suresh et al.'s model based on IIT was feasible. The profiles of the crack tip under constant-amplitude loading and three overload ratios were examined using optical microscopy. It was found that the geometry of crack tip changes significantly from the sharp crack to the blunt crack with increasing Rol after applying a tensile overload. The probable mechanisms resulting in the change of the crack-growth behavior due to tensile overloads were also discussed. It was suggested that the combined effects of the residual stress, crack tip profile and the crack tip hardening may be responsible for the observed overload retardation effect of the present M(T) specimens during fatigue crack growth.

EFFECT OF PRE-LOADING ON SHORT FATIGUE CRACK GROWTH AT A NOTCH

Effects of Tensile/compressive Overloads on Fatigue Crack Growth Behavior of an Extra-Low-interstitial Titanium Alloy

Instrumented indentation measurements of residual stresses around a crack tip under single tensile overloads

Effect of Residual Stress on Fatigue Behaviour of Notches

EFFECT OF NON-PROPORTIONAL OVERLOADINGON FATIGUE CRACK GROWTH

Finite Element Analysis Of The Effect Of The Compressive Loading On Fatigue Crack Growth Under Different Loading

Evaluation Of Excessive Loading Effect On Fatigue Crack Growth Behavior Based On Crack Blunting And Stress Distribution In Front Of The Crack Tip

STUDY OF FATIGUE CRACK GROWTH RETARDATION, CRACK TIP DEFORMATION AND CRACK CLOSURE UNDER SINGLE OVERLOAD APPLICATION FOR A537 STEEL

The compressive stress effect on fatigue crack growth under tension–compression loading

THE EFFECT OF NOTCH CONDITION ON THE BEHAVIORS OF SHORT FATIGUE CRACKS IN THE COMPOSITES OF SiC/LY12

Prediction Of Short Fatigue Crack-Growth In Compressive Residual-Stress Field

Analysis of the Effects of Compressive Stresses on Fatigue Crack Propagation Rate

Effects of Notch and Environment on High Cycle Fatigue Strength of Custom450 Steel

Prediction on fatigue limit of notches with non-propagating crack

Crack Tip Strain Evolution and Crack Closure During Overload of a Growing Fatigue Crack

Prediction of Notch Fatigue Limits in A Compressive Residual-Stress Field

Influence of Loading Path on Fatigue Crack Growth under Multiaxial Loading Condition

Fatigue Crack Propagation of the Notched Specimen under Cyclic Compression-Compression Loading Based on the Two-parameter Unified Approach

A Structural Stress Approach Accounting for Notch Effects on Fatigue Propagation Life: Part I Theory

Aspects Of The Residual-Stress Field At A Notch And Its Effect On Fatigue

Physically short fatigue crack growth from notch described by plasticity-corrected stress intensity factor