Measurement of surface tension and contact angle of solar salt at high temperature with axisymmetric drop-shape analysis
Kent P. Detrick,Michael Staker,Lydia Schouten,John P. Detrick,Dongjin Seo,Matthew Memmott
DOI: https://doi.org/10.1016/j.expthermflusci.2024.111383
IF: 3.2
2024-12-06
Experimental Thermal and Fluid Science
Abstract:As interfacial properties of common materials enabled many practical applications, those for molten salts would do the same. While their properties are important for the safety and design of thermal energy storage and modular nuclear reactors, they are hard to obtain because of the measurements done in confined spaces inside a furnace at high temperatures. Moreover, a small amount is preferred due to the high cost of salts. To overcome these limitations, an accurate method to measure surface tension, γ, and contact angles, θ , of molten salts were sought. As a steppingstone toward using more complex salts, solar salt was used because of safety and availability. Because molten salts typically show low θ , they provide large errors by incorrectly predicting volume and/or geometry. Therefore, various solid materials on which solar salts show high θ were sought and boron nitride was identified to provide θ > 60°. Later, solar salt sessile droplets were analyzed with the axisymmetric drop-shape analysis (ADSA) method to measure γ over a temperature range, which showed a good agreement with literature. Thus, this paper sets an experimental protocol that can be possibly used for other complex and hazardous salts that are scarcer and hard to handle. This paper extends the current knowledge by identifying solid surfaces on which the salts show low wettability for accurate measurements. Compared to other accurate methods, such as maximum bubble pressure method, this method used a small amount of salt (< 100 μL) while keeping a high accuracy.
engineering, mechanical,thermodynamics,physics, fluids & plasmas