Abstract:As a significant component of silver paste, glass frit has a nonnegligible effect on crystalline silicon solar cells. The purpose of this research is to obtain an analysis method to explore the performance of glass frit for solar cells. The samples were measured by digital microscopic system, and the three-dimensional layered tinting model was established. Moreover, the longitudinal cutting was carried out. The data of cross section was analyzed to obtain the information of melt height, wetting base angle, and melting included angle, to further infer the relationship between thermal stability, fluidity, wettability with mathematical model of glass frit through theoretical derivation. The curve fitting method was introduced in detail and the law was summarized. Based on relationship of them, the melting characteristics of glass frit could be quantitatively tested. The vertical view and surface topography were measured by the digital microscope and found that the glass frit underwent shrinkage, softening, wetting, spreading, and equilibrium during sintering. Combined with the image, abundant information was detected from the macroscopic structure of glass surface. Meanwhile, the mechanism of spreading was explained. Finally, the screen-printing technology combined with the 3D microscopic view of the silver grid line proved that glass frit with satisfactory performance can effectively reduce the contact resistance of solar cells, improve the photovoltaic conversion efficiency, verify the feasibility and accuracy of the simulation method equally. This study not only enriches the understanding of glass frit for crystalline silicon solar cells, but also provides a theoretical guidance for the research and determination of its performance.

Investigation of SiO2-B2O3-ZnO-Bi2O3 glass frits on the interface reaction of silver front contacts

The influence of Bi2O3 glass powder in silver paste on the fabrication of ohmic contacts and its potential effectiveness in solar cells and integrated circuits on p-type silicon substrates

Research on Silicon-Glass Thermal Bonding with SiO2 Film Assist

Effect of the interface glass on electrical performance of screen printed Ag thick-film contacts of Si solar cells

Thermal Properties of Glass Frit and Effects on Si Solar Cells

Insight of Effect of Silver Powders on Silver‐silicon Contacts of Crystalline Silicon Solar Cells through Analysis of Glass Structural Decay

Elucidation of the crystallization behavior and the thermodynamics property of CuO/Bi12SiO20@ SiO2-B2O3-Bi2O3-CuO glass-ceramics

Initiatively embedding silver colloids in glass used in silver paste to improve metallization ohmic contact on silicon wafers

Pb-free Silver Pastes with SnO-B2O3 Glass Frits for Crystalline Silicon Solar Cells

Effect of composition of front-electrode-paste glass on electrical performance of multicrystalline silicon solar cells

Sintering Behavior, Microstructure and Mechanical Properties of Various Fluorine-Containing Y-SiAlON Glass-Ceramics

EFFECT OF GLASS FRIT WETTING PROPERTY ON THE PERFORMANCES OF SILICON SOLAR CELLS

Effect of the Ag+ to Ag+/TiO2 film on the crystallization structure

Influence of Glass Phase in Silver Paste on Metallized Contact Resistance between Rear Silver and Aluminum Electrodes of Crystalline Silicon PERC Cells

Influence of nucleating agents on crystallization and electrical properties of SiO2–MgO–MgF2–K2O mica glass-ceramics

Sintering of a Crystallizable CaO‐B2O3‐SiO2 Glass with Silver

Microstructures and properties of (65-x)SiO2-xBi2O3-10B2O3-25CuO glasses

An analytical investigation on characterizing the properties of glass composition for crystalline silicon solar cells based on the digital microsystem measurement technology

Microstructure and Crystallization Behavior of Glasses in the ZrO2-ZnO-Al2O3-SiO2 System

The impact of semimetal nanoparticles on the conduction of thick glass layer at Ag/Si contact interface

The Co-Fired Behaviors Between Ag and Glass–ceramics Materials in LTCC