Abstract:A blast furnace operates under a countercurrent flow process, and a wide variety of physical and chemical reactions take place, especially in the hearth at the highest temperature. Therefore, the working status and erosion of the carbon brick have a critical influence on the longevity of the blast furnace. Although the phenomena in the hearth cannot be directly observed through the black box, hearth dissection provides an alternative way to access and subsequently evaluate the internal conditions. In this paper, a 4000 m3 blast furnace hearth was dissected, and 12 residual iron samples were collected and subjected to composition, morphology, and thermal conductivity analyses. The results show that in the center of the hearth, the residual iron had thicker metallic iron strips. This is because the residual iron in the center of the dissected hearth was fully mixed with carbon or coke, and this mixing apparently enhanced the heat conductivity in the center of the hearth to as great as 80.5 W/(m K). However, such a mixing state was gradually relieved in the regions either close to the wall or settling on the bottom. Thus, the residual iron near the wall formed a needle-like surface with a layer-by-layer structure in the form of alternatively thinner strip-shaped carbon and metallic iron, and the thermal conductivities of the residual iron near the wall were above 40.0 W/(m K) regardless of the relative height. Moreover, the erosion mechanisms of the blast furnace hearth wall are proposed, and the erosion thickness is accordingly evaluated based on the heat transfer model, in which the measured thermal conductivities of the residual iron are taken into consideration. According to the erosion mechanism, the thickness of residual iron is thinner, the erosion is more serious.

Calculation and Analysis the Influence on the Cooling Water Velocity and Hot Metal Circulation to the Long Life Bf

Cooling Water Flow Rate Calculation for Hearth of Large Blast Furnaces

Analysis of the Relationship between Productivity and Hearth Wall Temperature of a Commercial Blast Furnace and Model Prediction

Numerical Investigation of the Limit of Coke Rate Reduction in an Ironmaking Blast Furnace (BF)

Thermal Stress Analysis of Blast Furnace Hearth with Typical Erosion Based on Thermal Fluid-Solid Coupling

Computational Study of Hot Gas Injection (HGI) into an Ironmaking Blast Furnace (BF)

Numerical Simulation of Heat Transfer Behavior in Hot Spot Zone of Converter Molten Bath

Numerical Simulation of Blast Furnace Hearth Maintenance Measures

Numerical Analysis on Erosion and Optimization of a Blast Furnace Main Trough

Convective heat transfer boundary equivalent replacement and model simplification of cooling stave of blast furnace hearth

Calculation on effective heat of injected pulverized coal in blast furnace

Temperature Field Analyses of Lining With Cooling Plates and Stave for Blast Furnace

Optimization of HIsmelt reactor parameters for efficient combustion and heat transfer by numerical simulation

Numerical Simulation Model for Evaluating Protection Measures of Blast Furnace Hearth

3D Transient Heat Transfer Simulation and Optimization for Initial Stage of Steel Continuous Casting Process

Simulation of the Flow-Heat Transfer Process in Billet Mold and Analysis of the Billet Rhomboidity Phenomenon

Numerical Study on Heat Transfer Characteristic of Hot Metal Transportation before EAF Steelmaking Process

Numerical Simulation of Hot Metal Carbonization by Dead‐Man Coke in the Blast Furnace Hearth

Numerical Investigation of the Coupled Effect of H/D Ratio and Effective Volume on Optimized Blast Furnace Profile

Three-dimensional modelling of the wall heat transfer in the lower stack region of a blast furnace

Influence of the Residual Iron on the Erosion of Carbon Bricks in a 4000 m3 Blast Furnace Hearth: From the Measured Properties to the Proposed Mechanisms