Abstract:We propose and demonstrate a four-wavelength-switchable erbium-doped fiber laser (4WS-EDFL) with a four-channel superimposed high-birefringence fiber Bragg grating (SI-HBFBG) and a dual-coupler ring based compound-cavity (DCR-CC) filter. Both for the first time, a SI-HBFBG as a four-channel reflective filter is used in a multi-wavelength switchable fiber laser to define wavelength channels and a DCR-CC filter is used to select a single mode from dense longitudinal-modes in a fiber laser. We present in detail how to design, fabricate, and characterize the DCR-CC filter with both theoretical analysis and experimental results, which we believe is the first systematic approach for making a compound-cavity based filter used for selecting single-longitudinal mode (SLM) in a fiber laser. The enhanced polarization hole burning effect in a 2.9 m long erbium-doped fiber, coiled inside a three-loop polarization controller, and the polarization-mismatch-induced losses are introduced into the laser cavity to achieve wavelength-switching operations. We show that the 4WS-EDFL can be switched among fifteen lasing states, including four single-wavelength operations, six dual-wavelength operations, four three-wavelength operations and one four-wavelength operation, all with high stability. For demonstration, in switchable single-wavelength operations, the four SLM lasing outputs measured are all with an optical signal to noise ratio of >80 dB, a linewidth of <700 Hz, a relative intensity noise of ≤-156.7 dB/Hz at frequencies over 3 MHz, an output power fluctuation of ≤0.555 dB and excellent polarization characteristics.

3-Channel Single-Longitude-Mode Tunable Fiber Laser by Using A Digital-Micro-Mirror-Device Processor and Sub-Ring Cavities

Optimization of Few-Mode-Fiber Based Mode Converter for Mode Division Multiplexing Transmission

Three-channel Dual-Wavelength Fiber Laser Based on a Digital Micromirror-Device Processor and Photonic Crystal Fiber

A Widely Tunable Single-Longitudinal-mode Ytterbium-Doped Fiber Laser Based on Fiber Lyot Filter

Tunable mode-locked erbium-doped fiber laser based on a digital micro-mirror device

60-nm-Wide Tunable Single-Longitudinal-Mode Ytterbium Fiber Laser With Passive Multiple-Ring Cavity

Widely Wavelength Switchable V-Coupled-Cavity Semiconductor Laser With Similar To 40 Db Side-Mode Suppression Ratio

Widely Wavelength-Tunable High Power Single-Longitudinal-Mode Fiber Laser in Mid-Infrared Waveband

Narrow Line-Width Ytterbium-Doped Fiber Ring Laser Based on Saturated Absorber

16×100GHz digitally wavelength switchable V-coupled-cavity laser with 40dB SMSR

Single-mode and Wavelength Tunable Lasers Based on Deep-Submicron Slots Fabricated by Standard UV-lithography

Single-Longitudinal-Mode Erbium-Doped Fiber Ring Laser Based on High Finesse Fiber Bragg Grating Fabry–PÉrot Etalon

Direct Modulation of Deep-Submicron Slotted Single Mode FP Laser

Stable Single-Longitudinal-mode Fiber Laser Using PM FBG F-P Etalon and PM Fiber Saturable Absorber

High OSNR single-longitudinal-mode thulium-doped fiber laser based on a cascaded dual-ring cavity filter

Switchable single-longitudinal-mode dual-wavelength erbium-doped fiber ring laser incorporating a semiconductor optical amplifier.

Four-wavelength-switchable SLM fiber laser with sub-kHz linewidth using superimposed high-birefringence FBG and dual-coupler ring based compound-cavity filter

Dual-wavelength Erbium-Doped Fiber Laser with a Simple Linear Cavity and Its Application in Microwave Generation

A switchable and stable single-longitudinal-mode, dual-wavelength erbium-doped fiber laser assisted by Rayleigh backscattering in tapered fiber

Short-cavity single-longitudinal-mode dual-wavelength fiber laser and its linewidth measurement

Wavelength-Switchable 2 μm Single-Longitudinal-Mode Thulium-Doped Fiber Laser Based on Dual-Active Cavity and DLTCTR