Abstract:In preparation for the forthcoming High-Luminosity phase of the Large Hadron Collider, the ATLAS experiment is working on major upgrades to its detector systems to effectively accommodate the increase in radiation levels and track density. The foremost among these upgrades entails the replacement of the current inner tracking detector with an advanced all-silicon Inner Tracker (ITk). In the outer region of the ITk apparatus is the Strip Detector. Central to the new strip tracking system are the ITk Strip modules, comprising silicon sensors and hybrid Printed Circuit Boards housing the integral read-out Application-Specific Integrated Circuits (ASICs) as well as power distribution services. Thorough characterisation of the electrical characteristics of the silicon strip modules at various stages of the assembly procedure holds paramount significance in evaluating module performance. This rigorous evaluation ensures timely identification of any anomalies, thereby enabling proactive remedial measures. Notably, during the course of these electrical assessments, certain modules manifested breakdown phenomena occurring below the prescribed threshold of 500 V, mandated by the ITk Quality Control protocols. Based on these observations, controlled exposure to low levels of radiation was suspected to elevate the breakdown voltage in susceptible sensors. This contribution presents results from two irradiation campaigns to investigate potentially beneficial effects of irradiation. One study investigates the effects of gamma irradiation on modules showing an early breakdown after gluing. For this study, modules were exposed to an ionising dose of 11 krad (corresponding to the dose accumulated after several days of operation in the HL-LHC) utilising a 60 Co source. The second campaign focuses on silicon sensor test structures with low breakdown voltage due to intentionally caused mechanical defects and their development after exposure to reactor neutrons. In both cases, preliminary findings suggest a discernible improvement in the breakdown voltage.

Redundancy or Gaas? Two Different Approaches to Solve the Problem of Seu (single Event Upset) in A Digital Optical Link.

106.25 Gbaud On-Off Keying and Pulse Amplitude Modulation Links Supporting Next Generation Ethernet on Single Lambda

A prototype optical link board with redundancy design for the ATLAS liquid argon calorimeter Phase-2 upgrade

Optical Amplification-Free High Baudrate Links for Intra-Data Center Communications

106.25 Gbaud 4-Level Pulse Amplitude Modulation Links Supporting (2x)100gigabit Ethernet on Single Lambda.

Design and hardware evaluation of the optical-link system for the ATLAS Liquid Argon Calorimeter Phase-II Upgrade

Optical Links for ATLAS Liquid Argon Calorimeter Front-end Electronics Readout

Modulator-Based, High Bandwidth Optical Links for HEP Experiments

Curing early breakdown in silicon strip sensors with radiation

Test bench of a 100 Gbps radiation hardened link for future particle accelerators

Measurement of Single Event Effect cross section induced by monoenergetic protons on a 130 nm ASIC

Development of A 16:1 serializer for data transmission at 5 Gbps

Radiation test of commercial of the shelf (COTS) optical transceivers in the frame of the beam position monitor (BPM) consolidation project for the Large Hadron Collider (LHC)

Nonlinearity tolerance of RZ-AMI format in 42.7 Gbit∕s long-haul transmission over standard SMF spans

The design and test results of A Giga-Bit Cable Receiver (GBCR) for the ATLAS Inner Tracker Pixel Detector

New Optical Link Technologies for HEP Experiments

Optical Link ASICs for the LHC Upgrade

Optical Data Transmission ASICs for the High-Luminosity LHC (HL-LHC) Experiments

SPM Bulletin 15

Characterization of a gigabit transceiver for the ATLAS inner tracker pixel detector readout upgrade

Characterization and quality control test of a gigabit cable receiver ASIC (GBCR2) for the ATLAS Inner Tracker Detector upgrade