Abstract:In view of the High Luminosity LHC upgrade, the so-called Phase 2 upgrade, the electronics of the Drift Tubes (DT) subdetector of CMS will undergo a complete innovation. The requirements in terms of trigger rate will exceed the capabilities of the present electronics. Thus, all the on-detector electronics together with the associated back-end need to be replaced. Phase-2 on-detector electronics for DT consist of about 800 FPGAs (Field Programmable Gate Array) based boards called OBDT (On-detector Board for Drift Tubes). These boards are sub-divided in two different categories: 600 OBDT φ and 200 OBDT θ, targeting respectively the readout of DT wires parallel and normal to the LHC beams. Each OBDT φ is able to time-digitize 240 channels with sub-nanosecond resolution and upstream to the back end using multiple high-speed optical links running at 10.24 Gb/s. The choice of components known to have good resistance to radiation was a requirement in the design of the OBDT. The main component, the FPGA, is a flash-based PolarFire from Microsemi, already qualified in different facilities for radiation hardness tests. As a validation step, a campaign of radiation tests was carried out at the INFN-TIFPA Protontherapy Centre in Trento, Italy, using proton beams. The behavior of an OBDT φ board was evaluated during radiation exposure with a total dose much higher than expected to be integrated during 10 years of HL-LHC, which is 0.5 Gy.

Radiation test of commercial of the shelf (COTS) optical transceivers in the frame of the beam position monitor (BPM) consolidation project for the Large Hadron Collider (LHC)

Development of fiber beam loss monitor based on Cerenkov principle

106.25 Gbaud On-Off Keying and Pulse Amplitude Modulation Links Supporting Next Generation Ethernet on Single Lambda

Test bench of a 100 Gbps radiation hardened link for future particle accelerators

A Radiation-Tolerant 25.6-Gb/s High-Speed Transmitter in 28-nm CMOS With a Tolerance of 1 Grad

Fibre Monitoring System for the Beam Permit Loops at the LHC and Future Evolution of the Beam Interlock System

Radiation hardness and quality validation of the on-detector electronics for the CMS Drift Tubes upgrade

Optical Transmission Characterization of Fused Silica Materials Irradiated at the CERN Large Hadron Collider

Modulator-Based, High Bandwidth Optical Links for HEP Experiments

Irradiation Tests for Commercial Off-the Shelf Components with Atmospheric-like Neutrons and Heavy-Ions

Full C-Band Tunable V-Cavity-Laser Based Tosa and Sfp Transceiver Modules

A TOSA/ROSA-Based Optical Transmitter (MTx+)/Transceiver (MTRx+) for High-Energy Physics Experiments

Electronics design and testing of the CMS Fast Beam Condition Monitor for HL-LHC

The 120Gbps VCSEL Array Based Optical Transmitter (ATx) Development for the High-Luminosity LHC (HL-LHC) Experiments

Characteristics of the MTx optical transmitter in Total Ionizing Dose

Radiation Hardness of Two CMOS Prototypes for the ATLAS HL-LHC Upgrade Project.

Design and hardware evaluation of the optical-link system for the ATLAS Liquid Argon Calorimeter Phase-II Upgrade

Characterization of a gigabit transceiver for the ATLAS inner tracker pixel detector readout upgrade

Optical Data Transmission ASICs for the High-Luminosity LHC (HL-LHC) Experiments

A radiation tolerant clock generator for the CMS Endcap Timing Layer readout chip

Readout Electronics for CBM-TOF Super Module Quality Evaluation