Abstract:Friction measurements by an atomic force microscope (AFM) frequently showed regular stick-slip friction signals with atomic-scale resolutions. Typically, for an AFM metal tip sliding on a metal crystal surface, the microstructure of the tip made from the thermally evaporated metal coating on a silicon cantilever was polycrystalline. Our detailed molecular dynamics(MD) simulations of a polycrystalline Pt tip (<i>R</i> = 10 nm in radius) sliding on an Au(111) surface revealed how the geometry of the polycrystalline tip took effect on the friction behavior at the contact interface. We found that the apex of the Pt tip with multiple grains near the edge of contact could induce severe plastic deformations of the gold substrate, leading to irregular stick-slip frictions upon sliding. Simulation results showed that in order to achieve a clear stick-slip friction signal with single atomic slips, the apex of the Pt tip must adopt a single crystalline protrusion without any neighboring grains involved in the metal contact. We showed that such a single crystalline protrusion, which presumably could be achieved during initial run-in or wear-out of high-energy Pt atoms in the neighboring grains, was passivated by a large number of gold atoms due to metal adhesion in the contact periphery. Using such a crystalline protrusion tip, we demonstrated that the stick-slip friction produced was very "tolerant" to the adhesion of a large number of gold atoms on the tip apex. We further showed that AFM tip mass used in MD simulations also played an important role in determining the transition between friction regimes, which could be well explained by the Prandtl-Tomlinson thermal activation model.

Surface Morphology Investigation of Au and Pt Electroless Contact on ZnCdTe Crystal by Atomic Force Microscopy

Study of Electroless Au Film Deposition on ZnCdTe Crystal Surfaces

The Study on Schottky Contact Between Au and Clean CdZnTe

Research on Deforming Mechanism of Nanocrystalline Cu Thin Film under Contact Deformation

Surface Morphology, Crystal Orientation and Scratch Properties of Au/Nicr/Ta Multi-Layered Metallic Films

A Study of the Surface Structure of Deposited Au on Pb Film

Ohmic Contact of Pt/Au on Hydrogen-Terminated Single Crystal Diamond

The Interface Reaction and Schottky Barrier Between Metals and CdZnTe

Growth Of Au On Pt Icosahedral Nanoparticles Revealed By Low-Dose In Situ Tem

Interaction of surface energy and grain boundary energy during the growth of Au/NiCr/Ta film

Surface Structure Mediated Catalytic Activity Exhibition in Au Nanocrystals

Electronic Structure of the Pt(001) Surface with and Without an Adsorbed Gold Monolayer

Effect of low-temperature rapid annealing on structural and electrical properties of electroless platinum contacts on CdZnTe detectors

Structure Determination of Au on Pt(111) Surface: LEED, STM and DFT Study

Time resolved in situ liquid atomic force microscopy and simultaneous acoustic impedance electrochemical quartz crystal microbalance measurements: a study of Zn deposition

Application of Atomic-Force Microscopy to Metallography

The Study on the Work Function of CdZnTe with Different Surface States by Synchrotron Radiation Photoemission Spectroscopy

Oxide-Metal Interaction Probed by Scanning Tunneling Microscope Manipulation of Cr2O7 Clusters on Au(111)

Study of Tip-Sample Contact Process and Phase Contrast in Tapping Mode Atomic Force Microscopy

Characterization of the surface roughness and nanoindentation hardness of Au/NiCr/Ta multilayers

Will Polycrystalline Platinum Tip Sliding on a Gold(111) Surface Produce Regular Stick–Slip Friction?