Abstract:A combined steady-state and transient approach is employed to investigate the corrosion behavior of X80 pipeline steel in carbon dioxide-saturated brines. Continuous bubbling of carbon dioxide into a test vessel with 1 liter capacity is performed to simulate the flowing condition. The measurement of time-dependent open-circuit potential, polarization resistance, and electrochemical impedance spectroscopy (EIS) is conducted to interpret the evolution of dissolution processes at the corroding interface. Three distinguishing stages are observed at a temperature of 60 °C during a whole exposure of 144 h. Analyses mainly based on the consecutive mechanism show that after the first stage of the active-adsorption state, the anodic reaction is significantly retarded by the accumulation of (FeOH)ads on the iron surface, causing a sharp increase in the polarization resistance and the open-circuit potential, as well as the disappearance of the inductive loop in EIS. At the third stage, the formation of the corrosion product layer similarly reduces both the anodic and cathodic reactions, which arouses a linear increase in the polarization resistance with time and a capacitive loop in EIS but changes the open-circuit potential slightly. An increase in salinity in this study reduces the polarization resistance and enhances iron dissolution by promoting the formation and relaxation of (FeOH)ads; however, it brings little change to the developing time of the three stages obviously. At a low temperature of 20 °C, a protective product layer is not observed in carbon dioxide-saturated brine, and the dissolution of iron is mainly under activation control during the whole exposure. A notable enlarged polarization resistance and different interfacial processes are observed in an alkaline solution compared with those in acidic environments, which is deduced to be resulted from an impedance in the relaxation of (FeOH)ads by increasing pH. The observations in this study support well that the iron dissolution reaction at the initial stage exposed in carbon dioxide aqueous environments is dominant by water adsorption on the iron surface, and further investigation should be performed on the role that carbon dioxide plays in the evolution of corrosion products and the formation of a protective film on the steel surface by taking into account local water chemistry.

Electrochemical Impedance Spectroscopy Study of the Corrosion of 3cr Pipeline Steel in Simulated Co2-Saturated Oilfield Formation Waters

Electrochemical Impedance Spectroscopy Study on the Corrosion of the Weld Zone of 3cr Steel Welded Joints in CO2 Environments

EIS study of the surface film on the surface of carbon steel from supercritical carbon dioxide corrosion

Corrosion Behavior and In-Situ Ph Monitoring of a 3% Chromium Low Alloy Pipeline Steel Welded Joint in a CO2 Environment

EIS Studies of the Destruction Behavior of a Corrosion Inhibitor Film on Carbon Steel Surface under Hydrodynamic Conditions

Electrochemical Study of Corrosion Inhibition of Carbon Steel During Oil/Water Intermittent Wetting

Localized corrosion of carbon steel in a CO2-saturated oilfield formation water

Electrochemical Behavior and Corrosion Products of Casing Steel under CO2 Condition

EXPERIMENTAL STUDY OF CO_2 CORROSION OF 3Cr PIPE LINE STEEL

Chemical Analysis of the Initial Corrosion Layer on Pipeline Steels in Simulated CO2-enhanced Oil Recovery Brines

Electrochemical Investigation of the Corrosion of Different Microstructural Phases of X65 Pipeline Steel under Saturated Carbon Dioxide Conditions

Corrosion Behavior of Pipeline Steel Welds in Simulated Produced Water with Different Co2 Partial Pressures under High Temperature

STUDY ON SOIL CORROSION OF CARBON STEEL BY ELECTROCHEMICAL IMPEDANCE SPECTROSCOPY(EIS)

Probing and separating corrosion and erosion of pipeline steel using electrical resistance method in conjunction with electrochemical measurements

Monitoring Corrosion Fatigue Crack Formation on Drill Steel Using Electrochemical Impedance Spectroscopy: Experiment and Modeling

Corrosion of Pipelines in CO2-saturated Oil-Water Emulsion Flow Studied by Electrochemical Measurements and Computational Fluid Dynamics Modeling

Electrochemical Study on the Macro-Cell Corrosion of Pipeline Steel Partially Covered by Different Kinds of Mineral Deposits

Early Corrosion Stage of Welded Carbon Steel Joints in CO2-saturated Oilfield Water

Experimental Investigation on Corrosion Behavior of X80 Pipeline Steel under Carbon Dioxide Aqueous Conditions

A Novel Mathematical Method for Equivalent Circuit Modeling Determination for Electrochemical Impedance Spectroscopy to Study Corrosion Behavior of Corrosion Resistant Steel

Development on Electrochemical Impedance Spectroscopy Technology in Metal Corrosion and Coating Anticorrosion