Abstract:A combined steady-state and transient approach is employed to investigate the corrosion behavior of X80 pipeline steel in carbon dioxide-saturated brines. Continuous bubbling of carbon dioxide into a test vessel with 1 liter capacity is performed to simulate the flowing condition. The measurement of time-dependent open-circuit potential, polarization resistance, and electrochemical impedance spectroscopy (EIS) is conducted to interpret the evolution of dissolution processes at the corroding interface. Three distinguishing stages are observed at a temperature of 60 °C during a whole exposure of 144 h. Analyses mainly based on the consecutive mechanism show that after the first stage of the active-adsorption state, the anodic reaction is significantly retarded by the accumulation of (FeOH)ads on the iron surface, causing a sharp increase in the polarization resistance and the open-circuit potential, as well as the disappearance of the inductive loop in EIS. At the third stage, the formation of the corrosion product layer similarly reduces both the anodic and cathodic reactions, which arouses a linear increase in the polarization resistance with time and a capacitive loop in EIS but changes the open-circuit potential slightly. An increase in salinity in this study reduces the polarization resistance and enhances iron dissolution by promoting the formation and relaxation of (FeOH)ads; however, it brings little change to the developing time of the three stages obviously. At a low temperature of 20 °C, a protective product layer is not observed in carbon dioxide-saturated brine, and the dissolution of iron is mainly under activation control during the whole exposure. A notable enlarged polarization resistance and different interfacial processes are observed in an alkaline solution compared with those in acidic environments, which is deduced to be resulted from an impedance in the relaxation of (FeOH)ads by increasing pH. The observations in this study support well that the iron dissolution reaction at the initial stage exposed in carbon dioxide aqueous environments is dominant by water adsorption on the iron surface, and further investigation should be performed on the role that carbon dioxide plays in the evolution of corrosion products and the formation of a protective film on the steel surface by taking into account local water chemistry.

EIS Studies of the Destruction Behavior of a Corrosion Inhibitor Film on Carbon Steel Surface under Hydrodynamic Conditions

An investigation of the formation and destruction of corrosion inhibitor films using electrochemical impedance spectroscopy (EIS)

EIS study of the surface film on the surface of carbon steel from supercritical carbon dioxide corrosion

EIS measurement for corrosion monitoring under multiphase flow conditions

Study on corrosion inhibitor in large pipelines under multiphase flow using EIS

EIS STUDY ON THE DETERIORATION PROCESS OF ORGANIC COATINGS UNDER IMMERSION AND CYCLIC WET-DRY CONDITIONS

Comparative Studies on the Deterioration Process of Organic Coatings under Immersed and Cyclic Wet-Dry Conditions by EIS

Study on Performance of New Corrosion and Scale Inhibitor Composed of CA/HEDP/IA-SSA Copolymer

Corrosion Inhibition Properties of Corrosion Inhibitors to under-Deposit Corrosion of X65 Steel in CO2 Corrosion Conditions

Shielding against erosion: Exploring the effectiveness of pre-erosion surface corrosion inhibitors

Experimental Investigation on Corrosion Behavior of X80 Pipeline Steel under Carbon Dioxide Aqueous Conditions

Erosion–Corrosion Behavior of Friction Stud Welded Joints of X65 Pipelines in Simulated Seawater under Different Flow Rates

Revealing the Deterioration Effect of Scale Inhibitor on the Performance of Corrosion Inhibitor under Dynamic Conditions

Effect of Intermittent and Continuous Direct Current Electric Fields on the Initial Corrosion of Steel in Simulated Marine Environment

Effect of Rotating Speed and Hydrostatic Pressure on Erosion- Corrosion Behavior of X65 Pipeline Steel

Imidazoline behavior as corrosion inhibitor in the electrochemical characterization of SCC behavior of an API X70 steel exposed to brine solution

An Experimental Study on Cavitation Erosion-Corrosion Performance of ANSI 1020 and ANSI 4135 Steel

Experiments and Molecular Simulations to Study the Effect of Surface-Active Compounds in Mixtures of Model Oils on CO2 Corrosion during Intermittent Oil-Water Wetting

Errosion-Corrosion Critical Performance of Surface Nanocrystalline 20 Carbon Steel in Condensate Water

Erosion-Corrosion of AISI 302 Stainless Steel Sudden Expansion Pipes in High Salt Wastewater: Effect of Fluid Flow on Different Positions of a Sudden Expansion Pipe

Electrochemical Investigation of the Corrosion of Different Microstructural Phases of X65 Pipeline Steel under Saturated Carbon Dioxide Conditions