Abstract:A combined steady-state and transient approach is employed to investigate the corrosion behavior of X80 pipeline steel in carbon dioxide-saturated brines. Continuous bubbling of carbon dioxide into a test vessel with 1 liter capacity is performed to simulate the flowing condition. The measurement of time-dependent open-circuit potential, polarization resistance, and electrochemical impedance spectroscopy (EIS) is conducted to interpret the evolution of dissolution processes at the corroding interface. Three distinguishing stages are observed at a temperature of 60 °C during a whole exposure of 144 h. Analyses mainly based on the consecutive mechanism show that after the first stage of the active-adsorption state, the anodic reaction is significantly retarded by the accumulation of (FeOH)ads on the iron surface, causing a sharp increase in the polarization resistance and the open-circuit potential, as well as the disappearance of the inductive loop in EIS. At the third stage, the formation of the corrosion product layer similarly reduces both the anodic and cathodic reactions, which arouses a linear increase in the polarization resistance with time and a capacitive loop in EIS but changes the open-circuit potential slightly. An increase in salinity in this study reduces the polarization resistance and enhances iron dissolution by promoting the formation and relaxation of (FeOH)ads; however, it brings little change to the developing time of the three stages obviously. At a low temperature of 20 °C, a protective product layer is not observed in carbon dioxide-saturated brine, and the dissolution of iron is mainly under activation control during the whole exposure. A notable enlarged polarization resistance and different interfacial processes are observed in an alkaline solution compared with those in acidic environments, which is deduced to be resulted from an impedance in the relaxation of (FeOH)ads by increasing pH. The observations in this study support well that the iron dissolution reaction at the initial stage exposed in carbon dioxide aqueous environments is dominant by water adsorption on the iron surface, and further investigation should be performed on the role that carbon dioxide plays in the evolution of corrosion products and the formation of a protective film on the steel surface by taking into account local water chemistry.

EXPERIMENTAL STUDY OF CO_2 CORROSION OF 3Cr PIPE LINE STEEL

Corrosion Behaviors and Mechanical Properties of Q235 Steel Pipes Collapsing Due to Corrosion after 25-Year Service in Urban Industrial Atmospheric Environment

Corrosion of Cr bearing low alloy pipeline steel in CO2 environment at static and flowing conditions

Influence Of Microstructure On Mechanical Properties And Corrosion Behavior Of 3%Cr Steel In Co2 Environment

Experimental Investigation on Corrosion Behavior of X80 Pipeline Steel under Carbon Dioxide Aqueous Conditions

Chemical Analysis of the Initial Corrosion Layer on Pipeline Steels in Simulated CO2-enhanced Oil Recovery Brines

Corrosion Performance Analysis of Tubing Materials with Different Cr Contents in the CO2 Flooding Injection–Production Environment

Electrochemical Investigation of the Corrosion of Different Microstructural Phases of X65 Pipeline Steel under Saturated Carbon Dioxide Conditions

Study on corrosion properties of pipelines in simulated produced water saturated with supercritical CO2

Research of CO_2 Corrosion Kinetics of Tubing and Casing Steel P110

Evaluation of corrosion and erosion–corrosion behavior of X65 pipeline steel in flowing CO2-saturated electrolyte

Investigation of Supercritical CO2 Corrosion Behavior of X80 Carbon Steel in Pipelines: an in Situ Experimental and DFT Study

Corrosion Behavior of Novel Cr2monbti Pipeline Steel in Co2 Environment

Compare the Corrosion of 3%cr Steel with X65 Pipeline Steel in Subsea Co2 Top-Of-Line Corrosion Environment

Corrosion of Alloy Steels Containing 2% Chromium in CO2 Environments

Experimental Study on CO2 Corrosion of Super 13Cr Integrated Tubing with Erosion Damage

Electrochemical Study on the Macro-Cell Corrosion of Pipeline Steel Partially Covered by Different Kinds of Mineral Deposits

Study on the CO2 Corrosion Electrochemical Characteristics of 13Cr Steel at High Temperature and High Pressure

Research on the Corrosion Behavior of Q235 Pipeline Steel in an Atmospheric Environment through Experiment

Corrosion Behaviors of Several Kinds of Arc Sprayed Metal Coatings in Simulated Acid Soil Solution

Analysis of Corrosion Failure of 20# Steel Tubular Induction Probe in Simulated Environment of a Gas Field