Abstract:Dampness is one of the most important factors leading to the degradation of the insulation performance of cable accessories; it may easily lead to interface defects of composite insulation. In this paper, an electromagnetic field defect model of the cable composite insulation interface is established, and the effects of the defect degree and the defect type on the magnetic flux and the harmonic current are studied. The results show that the magnetic field is uniformly distributed with a decreasing trend when the cable is in good condition, and the grounding current has no obvious harmonic component. For different defects, the magnetic field changes at the defect location are notably different; for water droplets and the water film, the magnetic field distortion is obvious at the location of the defect and sheath, and for water tree defects, the distortion of the magnetic field is significant. In addition, the degree of distortion caused by the same defect at different positions is also different, and the magnetic field contrast is not obvious at different degrees of moisture exposure. The distortion of the grounding current caused by the water tree is higher than that of the water droplet and the water film, and the characteristics of the harmonic components of the grounding current caused by different defects have obvious distinctions. The type of cable defect can be judged by the proportion of harmonic components. This work can be used as a reference for the assessment of the cable insulation defect status.

The Impact of Coaxial Connector Failures on High Frequency Signal Transmission

State Influence of Adjacent Conductors Distributed Around Tested Channel in High-Speed Connector on Electromagnetic Measurement

Accurate Evaluation of Transmission Line Model at Higher Frequencies for Characterising Field-to-Wire Coupling of Coated Twisted-Wire Pair with a Grounded Conductor

Time-Domain Investigation on Cable-Induced Transient Coupling Into Metallic Enclosures

Transmission Line Model of Field-to-wire Coupling with Shielded TWP/Twinax Cables with line Apertures

Characterization of Electromagnetic Wave Coupling With a Noncoaxial Cable with Apertures on its Shield

Modeling and Characterization of On‐Chip Interconnects

Improved Design of Flange Mount Coaxial Connector With Low Passive Intermodulation Distortion

Measurement-based Models for Crosstalk Within a Connector Shell

Modeling and Analysis of Transmission Performance of Bonding Wire Interconnection

Numerical Characterization And Evaluation Of Esd Induced Field And Coupling On Interconnection Cable

Solder joint shape optimization and thermal-mechanical reliability improvement for microwave RF coaxial connectors

Signal Integrity Simulation and Analysis in High-Speed Interconnects by Using FDTD

Simulation and Experimental Study of the Influence of Temperature Stress on the Intermittent Fault of an Electrical Connector

Modeling And Evaluation Of Common-Mode Interference Coupling Effects On Sensitive Cable In Motor Drive System

Signal Propagation Effects on High‐speed Interconnection Lines Using Time‐domain Numerical Technique

Modeling and characterization of partially inserted electrical connector faults

A Statistical Model-Based Approach for Reproducing Intermittent Faults in Electrical Connectors under Varying Vibration Loading Conditions

Modeling and Analysis of Wide Frequency Band Coaxial TSV Transmission Interconnect

The Coupling Fields Characteristics of Cable Joints and Application in the Evaluation of Crimping Process Defects

Effect of Interface Defects on the Harmonic Currents in Distribution Cable Accessories under Damp Conditions