Abstract:Fluorescence-based sensing in droplet microfluidics requires small sample volumes, allows for high-throughput assays, and does not suffer from photobleaching as each flowing sensor is only scanned one time. In this paper, we report a selective and sensitive fluorescence-based ion-sensing methodology in droplet microfluidics using a T-junction PDMS chip. The oil stream is doped with sensor ingredients including an ionophore, a cation exchanger, and a permanently cationic fluorophore as the optical reporter. Electrolyte cations from the aqueous sample are extracted into oil segments and displace the cationic dyes into aqueous droplets. Laser-induced fluorescence of the two immiscible phases is collected alternately, which is in clear contrast to most other ion-selective optode configurations such as nanoparticle suspensions that rely on mixed optical signals of two phases. The cation exchanger, tetrakis[3,5-bis(trifluoromethyl)phenyl]borate, is found to dramatically enhance the dye emission in the nonpolar sensing oil by preventing ion-pairing interactions and aggregations of the dye molecules, providing new insights into the mechanism of cationic dye-based ion sensors. The high dye brightness allows us to use low concentrations of sensing chemicals (e.g., 10 μM) in the oil and attain high sensitivity for detection of ions in an equal volume of sample. Using valinomycin as the ionophore and methylene blue as the dye, K+ is detected with a response time of ∼11 s, a logarithmic linear range of 10–5 to 10–2 M, a 20-fold total fluorescence response, >1000-fold selectivity against other electrolyte cations, and negligible cross-sensitivity toward the sample pH. The K+ concentration in untreated and undiluted whole blood and sweat samples is successfully determined by this microfluidic sensing method without optical interference from the droplet sample to the sensing oil. Detection of other ionic analytes can be achieved using the corresponding ionophores.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acs.analchem.1c03394.Additional sensor characterization and comparison of performance characteristics of the microfluidic sensor and other sensors (PDF)This article has not yet been cited by other publications.

Ultra-sensitive Fluidic Sensors by Integrating Fluidic Circuits and Mosfets

Optical Micro/nanofibre Embedded Soft Film Enables Multifunctional Flow Sensing in Microfluidic Chips

An optical nanofibre-enabled on-chip single-nanoparticle sensor

Microfluidic Chip Based Microfiber/nanofiber Sensors

Optofluidic Micro-Nanofiber Sensors

Coiled Optical Nanofiber for Optofluidic Absorbance Detection.

Monolithic Integration of Vertical Thin-Film Transistors in Nanopores for Charge Sensing of Single Biomolecules

Ultra-Sensitive Nanofiber Fluorescence Detection In A Microfluidic Chip

Detection of Single Molecular DNA Charge Through TFT-Integrated Nanopore Biosensor

EFFICIENT CONTROL OF DNA TRANSPORT IN NANOPORE-BASED NANOFLUIDIC TRANSISTORS

Control of DNA capture by nanofluidic transistors.

Experimental Demonstration And Analysis Of Dna Passage In Nanopore-Based Nanofluidic Transistors

Field-effect Control of Ions Beyond Debye-Screening Limit in Nanofluidic Transistors

Detecting a Single Molecule Using a Micropore-Nanopore Hybrid Chip

Toward the Detection of Single Cell Releasing Through High Efficient Chip-Based Nano Fluidic Systems.

Bio-inspired flow rate sensor based on optical microfiber embedded soft film

Optofluidic Fabry–Pérot Cavity Biosensor with Integrated Flow-Through Micro-/Nanochannels

Nanoscale-localized multiplexed biological activation of field effect transistors for biosensing applications

Ion-Induced Phase Transfer of Cationic Dyes for Fluorescence-Based Electrolyte Sensing in Droplet Microfluidics

Local Electric Potential-Driven Nanofluidic Ion Transport for Ultrasensitive Biochemical Sensing

Ultrasensitive 3D Stacked Silicon Nanosheet Field-Effect Transistor Biosensor with Overcoming Debye Shielding Effect for Detection of DNA