Abstract:Ever more attention has been paid to geotechnical problems induced by wetting and drying of soils recently. Suction up to 80 kPa, measured by tensometers, has been used for analyzing geotechnical problems such as slope instability during wetting and drying. However, existing tensometer generally has a long response time and is easy to cavitate since it has a large volume of water reservoir and complicated internal structure. These drawbacks affect the sensitivity and reliability of a conventional tensometer seriously. In order to overcome these shortcomings, a newly developed fabricated tensometer is introduced. This type of new tensometer with fabricated structure has a simple internal structure and a small volume of water reservoir. At the same time, a drainage hole is introduced to prevent large excess pore water pressure during the process of reassembling. More importantly, its saturation procedure is simple and efficient since the high air-entry ceramic disc and pore pressure transducer of this new tensometer can be disassembled for saturation separately and effectively. After the saturation of the high air-entry ceramic disc and pore pressure transducer, these key components are reassembled together as a tensometer ready for use. As compared with a conventional tensometer, the sensitivity and reliability of this new tensometer are justified. The results of calibration test show that the sensitivity of the new tensometer increases by 90% by comparing with the conventional tensometer. In the case of measuring the pore water pressure of-80 kPa, the equilibrium time required for this new tensometer is only 1.5 minite, about 10%of that for the conventional tensiometer. Moreover, the reliability of the new tensometer is better than that of the conventional tensometer. The measurement error of the conventional tensiometer is about 30%, when measuring the pore water pressure of-80 kPa. Subjected to the same conditions, the new tensometer shows a measurement error of only 0.7%.

Development of a New High-Suction Tensiometer

Applications of a High-Capacity Tensiometer for Direct Measurement of Suction

Development of a New Fabricated Tensometer

A suction probe for direct measurement of high matric suction

Instrumentation of an Unsaturated Expansive Soil Slope

A new simple system for measuring volume changes in unsaturated soils

Effect of Suction Change on Water Content and Total Volume of an Expansive Clay

Study on the Pressure Retention Characteristic of a New Isobaric Water Sampler

A Combined Frequency Domain and Tensiometer Sensor for Determining Soil Water Characteristic Curves

Soil Total Suction Sensing Using Fiber-Optic Technology

Development of a Pore Gas Pressure Transducer Used in Unsaturated Soils at High Water Content

An Integrated High‐Capacity Tensiometer for Measuring Water Retention Curves Continuously

Dynamic Determination of Saturation-capillary Pressure Relationship in Air-water Two Phase Sandy Medium

An evaluation of the osmotic method of controlling suction

Recent developments in the techniques of controlling and measuring suction in unsaturated soils

A New Apparatus for the Measurement of Swelling Pressure Under Constant Volume Condition

Use of a differential pressure transducer for the monitoring of soil volume change in cyclic triaxial test on unsaturated soils

Hydromechanical Behavior of Unsaturated Soil with Different Initial Densities over a Wide Suction Range

Development of A Modified Axis Translation Technique for Measuring Swccs for Gravel Soils at Very Low Suctions

A Flexible-Wall Triaxial Permeameter for Localized Characterizations of Soil Suffusion