Abstract:Parameter values adopted in railway engineering analysis at present are generally obtained through triaxial tests, whereas the remarkable difference between the actual stress path during train passage and the loading path in cyclic triaxial tests may lead to inaccurate predictions and even engineering problems. Published researches show that the actual stress path probably contains principal stress rotation(PSR), which has a sisgnificant influence on the mechanical response of soil. However, the conventional approach, i.e. cyclic triaxial test is not efficient in simulating this complicated stress path involving PSR. Instead, hollow cylinder test with cyclic shear stress has been proved to be an excellent selection for PSR study. In order to obtain reliable stress path for guiding hollow cylinder tests, three-dimensional calculation for a certain urban railway is carried out; and the distribution regularity of cyclic stress amplitudes, cycle numbers and PSR under train loads is analyzed. Furthermore, a series of cyclic torsional shear tests on hollow cylinder samples is employed to simulate the complex stress path and to research the deformation and pore pressure accumulation properties of saturated soft clay. Considering stress in foundation soil decreasing along with the depth increasing, various cyclic stress amplitudes corresponding to different depths are adopted in this experiment study. Three-dimensional calculation shows that the major principal stress axis will rotate from -90 degrees to 90 degrees during the train loading passage as well as the number and amplitude of stress waves reduce gradually with the increase of depth. It is also shown that both PSR and stress are quite sensitive to train loads as the upper soil element can identify a single wheel load while the lower soil element can just identify a bogie and even the whole train load. And through the cyclic torsional shear tests, it's obvious that the rotation of principal stress can promote the accumulation of pore pressure and strain in soft soil foundations significantly; and in the case when vertical cyclic stress amplitude equals to 15 kPa, the pore pressure and strain in cyclic torsional shear test are 77% and nearly 50% higher than that in cyclic triaxial test respectively. What's more, as the cyclic stress amplitude increases, the gap of cumulative pore pressure and strain between that two types of tests will enlarge further, which may even result in essential difference that samples in triaxial tests show only small strain whereas failure in torsional shear tests.

Experimental research on long-term dynamic characteristics of unsaturated road base and subbase mixtures

Long Term Cyclic Behavior of Unsaturated Granular Soils

Influence of Matric Suction on the Long-Term Behavior of Fouled Road Base Materials Under Traffic Loading

Experimental Investigation into the Shakedown State of Unsaturated Road Base Aggregate at Various Fine Contents and Matric Suctions

The effects of suction history on the cyclic behavior of unsaturated road base filling materials

Resilient and permanent deformation of unsaturated unbound granular materials under cyclic loading by the large-scale triaxial tests

Undrained Behaviour of Intact Soft Clay under Cyclic Paths That Match Vehicle Loading Conditions

Undrained deformation behavior of saturated soft clay under long-term cyclic loading

Effects of Moisture Content on the Cyclic Behavior of Crushed Tuff Aggregates by Large-Scale Tri-Axial Test

Experimental study on dynamic characteristics of unbound granular materials under cyclic loading with different frequencies

Water Retention Behavior and Shear Strength of Artificially Cemented Granite Residual Soil Subjected to Free Drying

Influence Of Drainage Condition On Dynamic Cyclic Behavior Of Saturated Soft Clay Under Long-Term Cyclic Loading

Experimental Research on Static and Dynamic Characteristics of Cement Soil under Strain Control

Hypoplastic model for road base coarse-grained materials accounting for temperature effect

Influence of Grain Gradation on Permanent Strain of Unbound Granular Materials under Low Confining Pressure and High-Cycle Loading

Stress–strain Response of Soft Clay to Traffic Loading

Deformation behavior of K0-consolidated soft clay under traffic load-induced stress paths

Cyclic Deformation Behaviour of Natural K 0 -Consolidated Soft Clay under Different Stress Paths

Centrifuge Modeling of a Saturated Clay Ground under Cyclic Loading

Research on mechanical response of soft clay under cyclic loading involving principal stress rotation

One-Way Cyclic Triaxial Behavior of Saturated Clay: Comparison Between Constant and Variable Confining Pressure