Abstract:The hot deformation behaviors of Fe–28Mn–10Al–1.5C–0.6V steel at T = 950–1150 °C and = 0.01–10 s −1 were studied using the Gleeble-3500 thermo-mechanical simulator. The constitutive model of Fe–28Mn–10Al–1.5C–0.6V steel was established by an artificial neural network (ANN) based on the experimental flow stress data. The critical conditions of dynamic recrystallization (DRX) of the steel under experimental conditions were studied by using both the Najafizadeh–Jonas work hardening rate model and the Cingara–McQueen rheological stress model. The true stress–true strain curve of the steel was analyzed, the work hardening rate was calculated, and the critical strain model was established. At the same time, the relevant material parameters were calculated by linear regression, and the DRX kinetics model of JMAK was also established. This model then was combined with the finite element software DEFORM-3D to simulate the DRX behavior of the steel during hot deformation. These results indicated that the rheological stress of Fe–28Mn–10Al–1.5C–0.6V steel at low shows higher temperature sensitivity and that high T and low are conducive to the occurrence of DRX. The average relative error of the ANN constitutive model is 2.40%, which has high prediction accuracy. The dynamic recrystallization conditions determined by the above models are reliable and conform to the experimental rules. By verifying the microstructure of the steel after thermal compression, the prediction error of the finite element model to the DRX volume fraction is mostly within 10%. Thus, the model has a good predictive ability and provides an effective tool for predicting plastic deformation and microstructure in industrial production.

Research on flow stress model and dynamic recrystallization model of X12CrMoWVNbN10-1-1 steel

Dynamic Recrystallization Behavior and Constitutive Modeling of As-Cast 30cr2ni4mov Steel Based on Flow Curves

Investigation on Dynamic Recrystallization Behavior of Martensitic Stainless Steel

Constitutive Modeling for Elevated Temperature Flow Behavior of 30cr2ni4mov Ultra-super-crical Rotor Steel

Hot deformation behavior and dynamic recrystallization model of 35CrMo steel

Mathematical modeling for dynamic recrystallization behavior of 40Cr steel

Constitutive Analysis on High-Temperature Flow Behavior of 3Cr-1Si-1ni Ultra-High Strength Steel for Modeling of Flow Stress

Mathematical Modeling of Critical Condition for Dynamic Recrystallization

Thermal Flow Stress Constitutive Equation of Cr9Mo High-alloy Steel

Modeling of Dynamic Recrystallization and Flow Stress of Nb‐Bearing Steels

Research on hot deformation, dynamic recrystallization and numerical simulation of Fe–28Mn–10Al–1.5C–0.6V steel

Hot Deformation Behavior and Flow Stress Model of F40MnV Steel

Modeling of Dynamic Recrystallization Kinetics of a High Strength Low Alloy Steel During Hot Rolling

Modeling flow stress and grain size of GCr15 bearing steel at high-temperature deformation near end of solidification

Modeling the constitutive relationship of Cr 20Ni 25Mo 4Cu superaustenitic stainless steel during elevated temperature

Analysis on the Key Parameters to Predict Flow Stress during Ausforming in a High-Carbon Bainitic Steel

Evolution of austenite dislocation density during hot deformation using a physical dynamic recrystallization model

Uniaxial Mean Stress Relaxation of 9–12% Cr Steel at High Temperature: Experiments and Viscoplastic Constitutive Modeling

Flow Stress Models for 40Cr10Si2Mo Steel and Their Application in Numerical Simulation of Hot Forming

Research on Flow Stress Model of 38mnvs6 Non Quenched and Tempered Steel During Hot Forming

High Temperature Deformation Behavior and Constitutive Modelling for 05cr17ni4cu4nb Stainless Steel