Effect of Nano-Al2o3 on the Polarization of Polyimide Nanocomposite Films with Tri-Layer Structures

Hui Shi,Lizhu Liu,Ling Weng,Weiwei Cui,Yuanyuan Li
DOI: https://doi.org/10.1109/icpadm.2015.7295321
2015-01-01
Abstract:Polyimide (PI)/Aluminum oxide (Al2O3) nanocomposite films wtih tri-layer structures (PI-Al2O3/PI/PI-Al2O3) are manufactured from pyromellitic dianhydride (PMDA) and 4,4'-oxydianiline (ODA) via in-situ polymerization method. Microstructure, dielectric property and electrical conductivity of the nanocomposite films are characterized in this paper. Transmission Electron Microscope (TEM) and X-Ray Diffraction (XRD) results show that nano-Al2O3 particles are successfully introduced into target tri-layered structure and are homogeneously dispersed in the polyimide matrix. Compared with pure films, the obtained composite films perform lower relative permittivity at low nano-Al2O3 doping content (0-8wt%) and higher relative permittivity at high nano-Al2O3 doping content (>8wt%). The dielectric loss (loss tangent) of the composite films is higher than that of the pure films at the same frequency, and increases consistently with the increase of nano-Al2O3 content, especially in low frequency range. Furthermore, at the same nano-Al2O3 concentration, the dielectric loss of the composite films reduces at frequencies <10(3) Hz and increases at frequencies >10(3) Hz. The effect of nano-Al2O3 on electrical conductivity is only observed clearly at low frequency region (<10Hz). The above-mentioned dielectric property depends on the interaction and compromise of two kinds of polarization, i.e., interfacial polarization and anti-orientation polarization, which are attributed to the interfacial defect effect and blocking effect of nano-Al2O3 particles, respectively.
What problem does this paper attempt to address?