Abstract:In this study, we propose a three-dimensional (3D) surface temperature measurement method based on the principle of stereoscopic 3D reconstruction and the dependence of phosphorescence lifetime on temperature. A 385-nm UV(Ultraviolet) light was used as the excitation light, and two high-speed cameras were used as the detectors. The phosphor MFG (Mg4FGeO6: Mn4+) was mixed with the binder HPC and sprayed onto the tested 3D surface. The natural texture generated by the surface roughness of the phosphor coating was used as a feature for cross-correlation calculations. The digital image correlation (DIC) algorithm was used to match these feature positions in the phosphorescent images from the two cameras. The effects of the excitation angle and detecting angle were analyzed. The results indicate that the temperature measurement based on phosphorescent lifetime was not affected by the excitation and detecting angle. The method was validated on a turbine blade as an example of a 3D surface to demonstrate the capability. A comparison of the measurement results with the thermocouples proves that the current method can successfully measure the temperature on 3D surfaces with a maximum difference of 1.63°C. The spatial accuracy of the method was obtained by comparing with the measurement results of a 3D scanner, which shows that the maximum absolute error of the 3D reconstruction was 0.350 mm. The current study proposes a promising 3D surface temperature measurement method, which is expected to be widely used in gas turbine blades, Internal Combustion (IC) engine cylinders, complex curved heat exchangers, and other fields due to its non-contact measurement, low susceptibility to infrared radiation interference, high measurement accuracy, and ability to withstand harsh environments.

Use of a Thermographic Phosphor Fluorescence Imaging System for Simultaneous Measurement of Film Cooling Effectiveness and Heat Transfer Coefficient

Use of a Laser-Induced Fluorescence Thermal Imaging System for Film Cooling Heat Transfer Measurement

Measurements Of Surface Temperature And Heat Transfer Using A Fluorescence Imaging System Based On Thermographic Phosphors

Measurement of Surface Temperature Using a Laser-Induced Fluorescence Thermal Imaging System

A TEMPERATURE-GRADIENT CORRECTION METHOD FOR FILM COOLING EFFECTIVENESS MEASUREMENT USING ENDOSCOPE-BASED PSP TECHNIQUE

INVESTIGATION OF A QUASI-STEADY LIQUID CRYSTAL TECHNIQUE FOR FILM COOLING HEAT TRANSFER MEASUREMENTS

A Novel Indirect Visualization Method for Studying the Melting Heat Transfer of Nano-Enhanced Phase Change Materials Using Thermochromic Liquid Crystal Thermography

Temperature Measurement of a Curved Surface Using Thermographic Phosphors

Use of a laser-induced fluorescence thermal imaging system for local jet impingement heat transfer measurement

Rare-earth Phosphor Laser-Induced Fluorescence Thermal Imaging System

Evaluation of Heat Conduction and Visualization of Heat Flux in a Plate Making Use of Heat Transfer Experiments

A Novel Lifetime-Based Phosphor Thermography Using Three-Gate Scheme and a Low Frame-Rate Camera

Novel Strategy for Thermal Evaluation of Film-Cooled Blades Using Thermographic Phosphors at Simulated Engine Conditions

Determination of Local Heat Transfer Coefficient Based on Bulk Mean Temperature Using a Transient Liquid Crystals Technique

Heat diffusion imaging: In-plane thermal conductivity measurement of thin films in a broad temperature range

An On-Line Method for Thermal Diffusivity Detection of Thin Films Using Infrared Video

SURFACE HEATER FABRICATION USING MICRO-LITHOGRAPHY FOR TRANSPIRATION COOLING HEAT TRANSFER COEFFICIENT MEASUREMENTS

Two-color femtosecond laser pump and probe thermoreflectance method measuring nano-film thermal conductivity and interface thermal conductance

Three-dimensional Surface Temperature Measurement Using Lifetime-Based Phosphor Thermometry

Comparison of Lifetime-Based Methods for 2d Phosphor Thermometry in High-Temperature Environment

Design and Fabrication of a Thermopile-Based Thin Film Heat Flux Sensor, Using a Lead—Substrate Integration Method