Abstract:In road construction, the compaction process using vibratory rollers is essential to increase the ground stiffness in earthworks. There need to be clear standards regarding the operation of compaction rollers during compaction work. Various simple quality inspection techniques have been developed to check the stiffness of the ground, but plate load test and field density test are the most commonly used test methods to evaluate the degree of compaction during road construction. However, both inspection methods could be more efficient, as they cannot be performed in all sections due to time and cost. Additionally, in compaction work today, the worker will individually judge the number of compactions, thickness, speed, vibration etc. based on his or her own experience. This means that the quality of compaction varies depending on the worker. In this study, quality inspection results for all sections were obtained using an intelligent quality control system that employs an IC roller, a technology that is now commercially available. The effect of the operating conditions of the vibrating roller (roller compaction direction, compaction roller speed, and compaction roller vibration method) on the compaction quality was analyzed using the intelligent quality control value. Through our highway construction site tests, it was found that the speed of the compaction roller and the vibration method of the compaction roller affected the degree of compaction, but the direction of compaction did not. Therefore, if the compaction work is performed by adjusting the driving speed and vibration method of the vibrating roller according to the ground conditions, repetitive compaction work can be reduced, thereby reducing construction costs and lowering work time, which will achieve an improved work efficiency.

A New Method of Rapid Measurement Representing the Workability of Roller Compacted Concrete and the Application

Study on the consistency and mixture proportioning of roller compacted concrete for pavement

A Rapid Field Measurement Method for the Determination of Joint Roughness Coefficient of Large Rock Joint Surfaces

A Method for Real-Time Moisture Estimation Based on Self-Compacting Concrete Workability Detected During the Mixing Process

Compaction Quality Assessment of Rockfill Materials Using Roller-Integrated Acoustic Wave Detection Technique

Experimental Study on the Compaction Characteristics and Evaluation Method of Coarse-Grained Materials for Subgrade

A Study on the Analysis of the Ground Compaction Effect According to the Roller Operation Method through CMV Analysis Using IC Rollers

Assessment of compaction quality of highway subgrade via roller-integrated positive maximum velocity detection technique

New method of mix design for self-compacting concrete based on aggregate information

Compaction Quality Inspection Method of Soil-Rock Filled Embankment Based on Continuous Compaction Control Technology

Experimental Investigation of Mix Proportions Effects on Roller-Compacted Concrete Properties Using Response Surface Methodology

Influence of Compaction Methods on the Optimum Moisture Content and Performance of Roller Compacted Concrete Pavements

Assessment of Real-Time Compaction Quality Test Indexes for Rockfill Material Based on Roller Vibratory Acceleration Analysis

Studying the effect of the ratio of water to binder and sand to aggregate on the hardness of concrete mixtures and compressive strength of roller-compacted concrete by experimental method

New Method to Evaluate Rheological Behavior of High Fluidity Cement Paste and Mortar

Research on Design Indicators for Graded Crushed Stone Mixture Based on Vibration Molding Method

Improved Mechanical Models for Self-Compacting Concrete in the Paste Rheological Thresholds Theory Considering the Pressure Between Particles

Compaction Quality Evaluation of Subgrade Based on Soil Characteristics Assessment Using Machine Learning

A new method for measuring initial setting time of roller compacted concrete

Roller-Integrated Acoustic Wave Detection Technique for Rockfill Materials

New method for making and selecting the compaction plan of asphalt pavement based on compaction quality and carbon emissions