Abstract:Patterned alumina back contact on cadmium telluride (CdTe) solar cells can effectively mitigate the loss of the majority carriers while retaining the passivation benefits for minority carriers. This study investigates the impact of the point‐contact geometry on cell performance. The findings imply complex local carrier dynamics in the patterned back‐contact region, closely tied to the microstructural properties of CdTe‐based solar cells. Patterned aluminum oxide (Al2O3) back contact on cadmium telluride (CdTe) solar cells can effectively mitigate the loss of the majority carriers while retaining the passivation benefits for minority carriers. This study investigates the impact of the point‐contact geometry on cell performance, where the spacing of the microholes is systematically varied at a constant microhole diameter (≈16 μm). Microhole arrays are created on an evaporated Al2O3 layer (≈30 nm) on CdTe using laser‐beam lithography and selective wet etching processes. Comparative analysis indicates a significant decrease in fill factor (FF) and short‐circuit current (ISC) when the contact fraction falls below 30%, likely due to the Al2O3 barrier impeding majority carriers. Above this fraction, FF and ISC are comparable to those of baseline CdTe cells without Al2O3. Open‐circuit voltage (VOC) shows a gradual decrease as Al2O3 coverage is reduced but exhibits a slight increase (<15 mV) when the contact fraction exceeds 30%. Cathodoluminescence (CL) characterization reveals that significantly improved radiative recombination occurs within the CdTe grain bulk with Al2O3, whereas this effect on grain boundaries is minimal. The findings imply complex local carrier dynamics in the patterned back‐contact region, closely tied to the microstructural properties of CdTe‐based solar cells.

Effects of Postdeposition Treatments on Surfaces of Cdte/Cds Solar Cells

Effect Of Cdcl2 Annealing Treatment On Cds Thin Films And Cdte/Cds Thin Film Solar Cells

Cu-doped CdS and its application in CdTe thin film solar cell

Effects of Oxidation and CdCl2 Treatment on the Electronic Properties of CdTe Polycrystalline Films

Interface Formation between CdS and Alkali Postdeposition-Treated Cu(In,Ga)Se2 Thin-Film Solar Cell Absorbers-Key To Understanding the Efficiency Gain

High-efficiency CdTe-based Thin-Film Solar Cells with Unltrathin CdS:O Window Layer and Processes with Post Annealing

Comparison Between the Effects of CdCl 2 Heat Treatment on CdTe Films Prepared by RF Magnetron Sputtering and Close Spaced Sublimation Methods

The study on saturation current and ideality factor of CdTe solar cell based on CdS window layer deposited with hydrogen peroxide

Effect of CdCl_2 annealing treatment on interdiffusion and reaction at the CdS/CdTe interface

A microstructural study on the surface and interface of CdTe/CdS solar cells

Effect of High-Temperature Treatment in Air Ambience on the Surface-Composition and Structure of Cds

The Effects of ZnTe:Cu Back Contact on the Performance of CdTe Nanocrystal Solar Cells with Inverted Structure.

Copassivation of Polycrystalline CdTe Absorber by CuCl Thin Films for CdTe Solar Cells

Annealing Effects on the Chemical Deposited Cds Films and the Electrical Properties of Cds/Cdte Solar Cells

Contact wetting angle as a characterization technique for processing CdTe/CdS solar cells

Effect of CdCl2 Annealing Treatment on Thin CdS Films Prepared by Chemical Bath Deposition

Enhanced Performance of CdTe Solar Cells with Sb2Se3 Back Contacts

Annealing Effects on the Solution Processed CdTe Nanocrystals Solar Cells

[Study on back contact layer of CdTe solar cell by XPS]

Band Alignment for Rectification and Tunneling Effects in Al2O3 Atomic-Layer-Deposited on Back Contact for CdTe Solar Cell.

Microstructural Passivation of Patterned Al2O3 Back Contacts on CdS/CdTe Solar Cells