Abstract:Patterned alumina back contact on cadmium telluride (CdTe) solar cells can effectively mitigate the loss of the majority carriers while retaining the passivation benefits for minority carriers. This study investigates the impact of the point‐contact geometry on cell performance. The findings imply complex local carrier dynamics in the patterned back‐contact region, closely tied to the microstructural properties of CdTe‐based solar cells. Patterned aluminum oxide (Al2O3) back contact on cadmium telluride (CdTe) solar cells can effectively mitigate the loss of the majority carriers while retaining the passivation benefits for minority carriers. This study investigates the impact of the point‐contact geometry on cell performance, where the spacing of the microholes is systematically varied at a constant microhole diameter (≈16 μm). Microhole arrays are created on an evaporated Al2O3 layer (≈30 nm) on CdTe using laser‐beam lithography and selective wet etching processes. Comparative analysis indicates a significant decrease in fill factor (FF) and short‐circuit current (ISC) when the contact fraction falls below 30%, likely due to the Al2O3 barrier impeding majority carriers. Above this fraction, FF and ISC are comparable to those of baseline CdTe cells without Al2O3. Open‐circuit voltage (VOC) shows a gradual decrease as Al2O3 coverage is reduced but exhibits a slight increase (<15 mV) when the contact fraction exceeds 30%. Cathodoluminescence (CL) characterization reveals that significantly improved radiative recombination occurs within the CdTe grain bulk with Al2O3, whereas this effect on grain boundaries is minimal. The findings imply complex local carrier dynamics in the patterned back‐contact region, closely tied to the microstructural properties of CdTe‐based solar cells.

Contact wetting angle as a characterization technique for processing CdTe/CdS solar cells

A microstructural study on the surface and interface of CdTe/CdS solar cells

High-efficiency CdTe-based Thin-Film Solar Cells with Unltrathin CdS:O Window Layer and Processes with Post Annealing

Effects of Postdeposition Treatments on Surfaces of Cdte/Cds Solar Cells

Several Efficiency Influencing Factors in CdTe/CdS Solar Cells

Effects of High Temperature Annealing on Sputtered Zn(O,S) Films for CdTe Solar Cells

Effect of CdCl_2 annealing treatment on interdiffusion and reaction at the CdS/CdTe interface

Effect Of Cdcl2 Annealing Treatment On Cds Thin Films And Cdte/Cds Thin Film Solar Cells

Annealing Effects on the Solution Processed CdTe Nanocrystals Solar Cells

Cu-doped CdS and its application in CdTe thin film solar cell

Optimizing CdTe-metal interfaces for high performance solar cells

Water-assisted Exfoliation of Epitaxial CdTe Film from Mica Analyzed with Azimuthal RHEED

Enhanced Performance of CdTe Solar Cells with Sb2Se3 Back Contacts

A Study of Back Contacts of Cdte Thin Film. Solar Cells

Microstructural Passivation of Patterned Al2O3 Back Contacts on CdS/CdTe Solar Cells

Critical issues of CdTe thin film solar cells

The surface leakage currents of CdZnTe wafers

Comprehensive study of physical properties of cadmium telluride thin films: effect of post-deposition high annealing temperature

Two-stage annealing-induced secondary grain growth for enhanced efficiency in CdTe solar cells on flexible polyimide foils

CdTe X/γ-ray Detectors with Different Contact Materials

Assessment and Interpretation of Surface Wettability Based on Sessile Droplet Contact Angle Measurement: Challenges and Opportunities