Abstract:BACKGROUND:Conventional ways of making bio-electrodes are generally complicated, expensive and unconformable. Here we describe for the first time the method of applying Ga-based liquid metal ink as drawable electrocardiogram (ECG) electrodes. Such material owns unique merits in both liquid phase conformability and high electrical conductivity, which provides flexible ways for making electrical circuits on skin surface and a prospective substitution of conventional rigid printed circuit boards (PCBs). METHODS:Fundamental measurements of impedance and polarization voltage of the liquid metal ink were carried out to evaluate its basic electrical properties. Conceptual experiments were performed to draw the alloy as bio-electrodes to acquire ECG signals from both rabbit and human via a wireless module developed on the mobile phone. Further, a typical electrical circuit was drawn in the palm with the ink to demonstrate its potential of implementing more sophisticated skin circuits. RESULTS:With an oxide concentration of 0.34%, the resistivity of the liquid metal ink was measured as 44.1 µΩ·cm with quite low reactance in the form of straight line. Its peak polarization voltage with the physiological saline was detected as -0.73 V. The quality of ECG wave detected from the liquid metal electrodes was found as good as that of conventional electrodes, from both rabbit and human experiments. In addition, the circuit drawn with the liquid metal ink in the palm also runs efficiently. When the loop was switched on, all the light emitting diodes (LEDs) were lit and emitted colorful lights. CONCLUSIONS:The liquid metal ink promises unique printable electrical properties as both bio-electrodes and electrical wires. The implemented ECG measurement on biological surface and the successfully run skin circuit demonstrated the conformability and attachment of the liquid metal. The present method is expected to innovate future physiological measurement and biological circuit manufacturing technique in a large extent.

Development of Three-Dimension Microelectrode Array for Bioelectric Measurement Using the Liquidmetal-Micromolding Technique

Low Melting Point Metal-Based Flexible 3D Biomedical Microelectrode Array by Phase Transition Method.

Wafer-patterned, permeable, and stretchable liquid metal microelectrodes for implantable bioelectronics with chronic biocompatibility

Injectable 3-D Fabrication of Medical Electronics at the Target Biological Tissues.

A Flexible Microneedle Electrode Array with Solid Silicon Needles

Low-Cost, Metal-Based Micro-Needle Electrode Array (M-Mnea): A Three-Dimensional Intracortical Neural Interface

Electroplated microneedle array for biomedical applications

3D Polymeric Lattice Microstructure‐Based Microneedle Array for Transdermal Electrochemical Biosensing

Fully Printed μ-Needle Electrode Array from Conductive Polymer Ink for Bioelectronic Applications

Low-Cost, Low-Impedance Polyimide Based Micro-Needle Array (PI-MNA): A Minimally Invasive Flexible Dry Electrode for Surface Bio-Potential Monitoring

Application of MEMS Microneedles Array in Biomedicine

Three-Dimensional Electrodes of Liquid Metals for Long-Term, Wireless Cardiac Analysis and Modulation

Fabrication of barbed-microneedle array for bio-signal measurement

A novel 3D flexible parylene-metal structure fabrication technique

Geometrical effects in mechanical characterizing of microneedle for biomedical applications

Development and Evaluation of 3D‐Printed Dry Microneedle Electrodes for Surface Electromyography

Surface Biopotential Monitoring by Needle Type Micro Electrode Array

Highly stretchable and customizable microneedle electrode arrays for intramuscular electromyography

Fabrication of sharp silicon hollow microneedles by deep-reactive ion etching towards minimally invasive diagnostics

Biomedical implementation of liquid metal ink as drawable ECG electrode and skin circuit.

Fabrication and properties of 3D flexible parylene-based microelectrode array with silicon tips